Wt7600ha Parts

Replace your washer's detergent dispenser box assembly if cracked, broken, or leaking. This component holds and distributes detergent during wash cycles.

Protective cover for washer control panel or component housing. Replaces cracked, broken, or missing covers. Shields internal parts from damage.

This front decor panel is the exterior trim piece that restores the microwave's finished appearance and covers the control/magnetron cavity edges for a clean look. It replaces damaged or discolored front trim to improve aesthetics. What it does:

• Replaces the microwave's front trim to restore the appliance's factory appearance.
• Covers and protects the control/door edges from dirt and cosmetic damage.
• Helps maintain a consistent finish when the original panel is dented, scratched, or faded.
• Matches OEM fit and attachment points for straightforward replacement when the correct part number is used.

• One decor panel (front trim) as shown.

• Disconnect power (unplug or switch off breaker) before starting any work.
• Remove the microwave door or control housing per OEM service instructions to access mounting screws; keep hardware separate for reassembly.
• Handle edges carefully to avoid cuts and protect finish from scratches; use soft cloths when aligning the panel.

This rear panel is the outer back cabinet piece that protects internal components and helps keep the appliance's enclosure rigid and ventilated. Replaces a cracked, dented or missing back panel to restore protection and fit. What it does

• Covers and protects internal parts from debris and accidental contact
• Helps maintain cabinet rigidity and proper component alignment
• Supports ventilation openings and prevents airflow obstructions
• Stops rattling or scraping caused by loose or damaged rear enclosure

• One rear panel

• Disconnect power and water before starting any repair
• Typical installation requires removing rear access screws and lifting the old panel off; use proper hand tools
• Handle edges carefully—panels and fasteners can be sharp
• Keep all mounting screws and insulation pieces for reinstallation

The Housing Assembly, Clutch is an OEM part for LG washing machines. It is integral to the washing machine's transmission system, helping to engage and disengage the tub during wash and spin cycles.

You should replace this clutch housing assembly if it becomes worn out or damaged. Over time, the clutch can wear out due to repeated use, heavy loads, or poor maintenance. Additionally, debris or foreign objects can cause damage to the housing or internal components.

Symptoms of a bad clutch housing assembly include:

• Washing machine not spinning or agitating properly
• Excessive noise during wash or spin cycles
• The washer not completing cycles or stopping mid-cycle

This OEM LG part is also compatible with Sears/Kenmore models.

Fix a washer with no display or unresponsive controls. This display control board assembly restores full panel functionality. Moderate DIY repair.

The washer pulsator is located at the bottom center of top-loading washing machines and creates the agitating motion that cleans clothes. Replace if clothes aren't getting clean, the pulsator is cracked or loose, or you notice reduced agitation during wash cycles.