Wtmc652suc/02 Parts

This is a factory-style screw used to secure appliance panels and components for a reliable, low-profile hold. It replaces worn or missing fasteners to stop rattling and keep parts aligned during normal use. What it does:

• Secures trim, panels, brackets or small components in place
• Stops loose parts that can cause rattling or vibration noises
• Restores correct fit where a missing or damaged screw allows gaps
• Works as a direct replacement when the original fastener is lost or stripped

• One screw

• Disconnect power and water before servicing the appliance
• Start the screw by hand to avoid cross-threading; use the correct driver bit
• Tighten snugly but avoid over-torquing to prevent stripping or part damage
• Keep removed hardware organized to ensure correct reassembly

Replacement mounting screw that secures panels, brackets and trim on compatible Bosch appliances. Restores proper fastening to reduce rattling, loose parts and alignment issues for safer, quieter operation. What it does:

• Secures panels, brackets, trim pieces and small appliance components.
• Replaces missing, stripped or corroded screws that allow parts to vibrate or become misaligned.
• Helps restore proper fit and reduces noise caused by loose or shifting components.
• Used wherever the original screw fastens service panels or mounting brackets.

• Disconnect power to the appliance before beginning any repair work.
• Use the correct driver bit to avoid stripping the screw head; apply firm, steady pressure.
• Do not overtighten—tighten until snug and parts are secure to avoid damaging threads or components.
• If original threads are damaged, inspect mating component and replace damaged parts or use appropriate thread repair methods.

This sealing strip replaces a worn or damaged door edge seal to help maintain a tight closure and reduce leaks, drafts, and odors. It restores proper sealing where the door meets the cabinet or frame. What it does:

• Provides a consistent seal along the door edge to help prevent water or air leaks
• Helps limit odors and moisture transfer from the appliance compartment
• Reduces rattling or wind noise caused by a compromised door seal
• Restores smooth door closure and alignment where the strip seats

• Disconnect power and water supply before starting work
• Remove the old strip carefully to avoid damaging the door or frame
• Align the new strip with the door edge and press into the channel or mounting surface per OEM guidance
• Trim excess only if specified by the manufacturer; check for a secure, continuous seal after installation

This genuine refrigerator door seal replaces a worn or damaged gasket to help restore proper door sealing and keep cold air inside. It reduces cycling and helps maintain consistent temperatures for stored food. What it does:

• Creates a tight seal around the refrigerator door to prevent air leaks
• Helps stop frost buildup and reduces overworking of the compressor
• Commonly replaces seals that are torn, flattened, or no longer sealing
• Fits specific Bosch refrigerator doors — improves cooling performance when seal is compromised

• Disconnect power to the appliance before starting any repair
• Remove food, shelves, and door liners as needed for access
• Warm the gasket slightly (room temperature or warm water) to ease installation; avoid open flames or excessive heat
• Inspect door frame for damage and ensure the seal is seated evenly to allow full door closure

This flat washer secures fasteners and helps distribute clamping force to protect parts from pull-through and wear. It's a small but critical hardware piece that helps maintain proper alignment and reduce vibration in the appliance. What it does:

• Sits under a nut or bolt to evenly spread load and prevent surface damage
• Helps keep fasteners tightened and reduces loosening from vibration
• Protects mating surfaces from wear and deformation
• Can reduce rattling or vibration-related noise when used as intended

• Disconnect power and water before accessing internal components
• Replace like-for-like; do not force or modify the washer to fit
• If other hardware is corroded or damaged, replace affected fasteners as a set