Rps Sensor Parts

Oven won't heat or stops mid-cycle? A blown thermal fuse cuts power when temperatures exceed safe limits. This part restores heating and protection.

Refrigerator not cooling or frosting up? This defrost thermostat controls when the defrost heater turns off, preventing ice buildup on evaporator coils.

Fix dishwasher not heating or filling issues with a new sump thermistor. This sensor regulates water temperature for optimal cleaning performance.

If your air conditioner won't power on or has no display, a blown fuse may be the cause. This fuse protects the electrical circuit from surges and shorts.

Air conditioner won't turn on or suddenly stops working? A blown electrical fuse is often the cause. This fuse protects your unit's circuitry.

Dryer won't heat or overheats? This high-limit thermostat opens the heating circuit at preset temperatures to prevent overheating and restore safe operation.

Fix microwave overheating or uneven cooking with this thermistor. Monitors oven temperature for proper operation. Simple DIY repair in 15-20 minutes.

Microwave won't start or stops mid-cycle? A blown fuse is often the culprit. This 5 amp fuse protects your microwave's electrical system. Quick DIY fix.

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

Freezer not cooling or frosting over? This defrost thermostat monitors temperature and controls the defrost cycle to prevent ice buildup and restore airflow.

This evaporator wire harness delivers power and control signals to the evaporator fan and defrost components. Replace a damaged harness to restore stable cooling and dependable automatic defrost performance. What it does:

• Provides plug-in electrical connections for evaporator-compartment components
• Carries power and control signals for cooling and defrost cycles
• Enables proper airflow across the evaporator and effective frost removal
• Common clues of a failing harness: heavy frost on the back wall, evaporator fan not running, intermittent cooling, or burned/brittle wires or connectors

• 1 evaporator wire harness assembly

• Disconnect power to the refrigerator before servicing
• Access the harness behind the freezer/evaporator cover; remove drawers/shelves and the rear panel
• If iced over, allow ice to melt—do not use sharp tools on coils or wiring
• Route and secure the new harness exactly like the original; fully seat each connector

Dryer won't start or stops mid-cycle? A blown thermal fuse is often the cause. This safety component cuts power when temperatures get too high.