Hardware Hand Small Engine On-Off Switch Parts

Fix a washer that won't fill properly, overfills, or stops mid-cycle. This pressure switch restores proper water level detection. Simple 10-minute repair.

For switch mounting nut, order part# WP422617.

This main wire harness routes power and control signals between the appliance's control board and components to restore electrical connectivity and reliable operation. Replacing a damaged harness helps eliminate intermittent faults and lost functions. What it does:

• Provides the primary electrical connections between the control board and motors, switches, sensors and valves
• Carries power and signal wiring so controls and components operate as intended
• Commonly replaces harnesses with broken, melted, or corroded wires or connectors
• Can resolve symptoms such as no power to components, intermittent operation, or unresponsive controls

• Disconnect power to the appliance before inspecting or replacing the harness
• Compare connector types and routing to the original harness; install in the same path to avoid chafing
• Secure connectors fully until they click; avoid pulling on individual wires
• If wiring or connectors show heat damage or corrosion beyond the harness, inspect associated components.

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

Replacement mounting screw that secures panels, trim, and internal components in microwaves and wall ovens. Needed when screws are stripped, missing, or lost.

Size: 6-20 x 0.312 inch.

Range hood light or fan not responding? This control switch restores operation of blower speeds and lighting. Straightforward DIY repair in under 30 minutes.

The range hood speed control wire harness is the set of wires that connects the fan speed switch to the hood's motor, transmitting the signals that control airflow levels. It ensures your hood fan operates correctly at each selected speed setting. Replace this part if your range hood fan only runs at one speed, won't turn on at certain settings, or if you notice burnt or damaged wiring.

Replacement mounting screw for electric ranges. Secures panels, brackets, and trim to the appliance frame. Replace if missing, stripped, or rusted.

1/4-20 threaded screw secures panels, brackets, and internal assemblies in ranges, ovens, and cooktops. Replace missing, stripped, or corroded fasteners.

Mounting screw for electric and gas ranges. Secures panels, brackets, or internal components. Replace if lost, stripped, or damaged during repair.

Secures microwave to wall cabinet mounting bracket. Replace if cracked, stripped, or missing to restore proper cabinet installation and stability.

Secures microwave components to their mounting points. Replace this nut assembly if damaged, missing, or worn to prevent rattling and keep parts aligned.

This flat washer (.250 inch inner diameter x .812 inch outer diameter) is a simple replacement part that helps distribute load from a fastener and protects mating surfaces for reliable appliance operation. What it does:

• Provides a stable bearing surface for screws, bolts or studs to reduce wear on parts
• Helps distribute clamping force to prevent pull-through or deformation of softer materials
• Reduces vibration and movement at the joint when installed correctly
• Missing or damaged washers can lead to loose fasteners, increased vibration or component misalignment

• Disconnect power and water before servicing the appliance
• Replace like-for-like: inner/outer diameters and thickness match the original washer
• Inspect mating hardware and surfaces for damage; replace corroded or deformed fasteners as needed
• Tighten fasteners evenly and avoid over-torquing to prevent washer or component damage

Black-finished screw secures oven panels, trim, and brackets. Replace missing or damaged fasteners to restore solid fit and prevent rattling or gaps.

Oven light switch.