Hardware Hand Small Engine Spark Plug Parts
Genuine Bosch part
By: Bosch
Part Number: 00263088
Detergent door won't close or stay shut? Replace the dispenser assembly. Takes about 20 minutes with basic tools—remove inner door panel and swap out.
Do-It-Yourself Stories from Customers like You
Dispenser no longer opened Douglas L. • Fountain Hills , AZ • April 22, 2014
Removed back of dishwasher with hex screw driver 5 min
Unplugged power cord 30 secs
Loosened metal bracket on top and bottom with screwdriver 5 min
Pushed dispenser in and removed from dishwasher 5 min
Positioned new unit in space and snapped into place 1 min
Plugged electrics back in 1 min
Screwed back on 3 min
Roughly 20 min. I am nontechnical and rarely do repairs.
Read more
More
$210.39
- Compare At:
-
$250.36
- You Save:
-
$39.97
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB02T10452
Reinforcement spacer maintains proper gap and support between panels, trim, or brackets. Replace if worn, missing, or cracked to restore alignment.
Do-It-Yourself Stories from Customers like You
Screw head broke of handle Ward B. • Conway , AR • August 27, 2025
Ordered the 3 parts that hold the handle to the glass. Replacements fit perfectly and the repair only took 10 minutes to complete.
Read more
More
$11.68
- Compare At:
-
$13.90
- You Save:
-
$2.22
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00267739
Rear pump housing for the washer drain/pump assembly. Replaces the worn rear housing that supports the impeller and bearing, helping restore proper draining and reduce leaks or unusual pump noises when the housing fails. What it does:
- Houses and supports the pump impeller and bearing, forming the rear half of the drain pump assembly.
- Restores a sealed mounting surface to help prevent water leaks from the pump area.
- Helps re-establish correct water flow and draining when a cracked or worn housing impairs the pump.
- Addresses symptoms such as poor or no draining, water at the base of the appliance, or loud/grinding pump noises.
What's included: One rear pump housing. Install notes:
- Disconnect power and shut off water supply before starting; drain any standing water to avoid spills.
- Remove the washer access panels and pump assembly; transfer the impeller, seals, and any hardware as required.
- Inspect and replace pump gaskets/seals and the impeller if worn; tighten mounting fasteners to OEM torque where specified.
Do-It-Yourself Stories from Customers like You
Very little water pressure coming from spray arms only sprayed about 6" Kevin H. • San Antonio , TX • August 18, 2019
Our Bosch suddenly quit washing the dishes properly after 15 years of faithful service. I observed that there was no pressure coming from the sprayers, and determined it to be the circulating pump. I could reach into the pump from inside the dishwasher and could feel that something was loose in there - the impeller moved when pumping, but I could stop it with my finger.
When I took the pump out and disassembled it, the impeller was in two pieces (the front and back pieces that are supposed...
Read more
More
$35.49
- Compare At:
-
$42.23
- You Save:
-
$6.74
Out Of Stock
Usually ships within 4 - 14 days
Genuine Lg part
By: Lg
Part Number: 1NHB0500032
The Common Nut is an OEM part for LG ranges. It secures the fan blade to the motor shaft. This nut maintains the fan's stability and preventing it from becoming dislodged during use.
Causes of a bad common nut can include loosening over time due to vibration, improper installation, or damage from impact or mishandling.
Symptoms of a bad common nut include:
- Excessive noise or vibration from the fan assembly
- The fan blade becoming loose or detached, causing poor air circulation
- Potential risk of the fan blade becoming a projectile if completely detached
This OEM LG part is also compatible with some Kenmore models.a
More
$10.58
- Compare At:
-
$11.64
- You Save:
-
$1.06
Out Of Stock
Usually ships within 4 - 14 days
Genuine Lg part
By: Lg
Part Number: 1NZZW1A004D
Fastener nut secures internal components in your microwave. Replace if stripped, rusted, or missing to restore tight hold and proper panel alignment.
Do-It-Yourself Stories from Customers like You
AC fan motor. Tom C. • Liberty Lake , WA • September 26, 2021
Disassembled and replaced ac motor.
The hardest part was to pull the microwave out of the cabinet.
Read more
More
$7.43
- Compare At:
-
$8.77
- You Save:
-
$1.34
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR2X8233
This plug button is a small snap-in cap used on refrigerators to cover exposed holes on door handles, liners, or trim. It restores a clean, finished look while helping keep dust and moisture out of the cabinet.
- Snaps into a screw or access hole on a handle, liner, or trim panel
- Covers fasteners and gaps for a clean, finished appearance
- Helps block dirt and moisture from open holes
- Typical symptoms: missing cap, broken or loose plug, visible screw hole or cosmetic gap
What's included: 1 plug button
- Unplug the appliance before servicing and use caution around sharp edges
- Align the plug with the hole and press straight in by hand until fully seated and flush
- For handle screw holes, tighten fasteners first, then install the cap
- Avoid using metal tools on finished surfaces to prevent scratches
Do-It-Yourself Stories from Customers like You
Refrigerator needed a new handle. Jan H. • Seminole , FL • August 27, 2020
We spoke with Cassie, who was a TREMEMDOUS help! We didn’t think we could locate the right color for the fridge, but with her help and expertise working with model numbers and related nuances, she homed right in on what we needed.
We received the materials in 2 separate shipments (a few days apart) and all went according to plan. We couldn’t be happier.
Read more
More
$7.95
- Compare At:
-
$9.54
- You Save:
-
$1.59
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WD21X10355
Connects dishwasher wiring to the water inlet valve. Replace if the plug is burnt, brittle, loose, or corroded to restore a secure electrical connection.
Do-It-Yourself Stories from Customers like You
GE dishwasher was not filling water. A M. • Aurora , CO • October 13, 2018
Dishwasher had begun going through the cycles with not enough water in the chamber. Suspect was the water inlet valve. Checked the AppliancePartsPros video for this repair and ordered the valve from them. It arrived in a timely manner -as usual- and I pulled the dishwasher out, removed the kick toe cover, then the structural brace behind it then removed the valve. Installed the new valve, replaced the bracket and the toe cover and dish washer is back in service like brand new.
Wife was ready to...
Read more
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Out Of Stock
Usually ships within 4 - 14 days
Genuine Bosch part
By: Bosch
Part Number: 00264946
Replacement front cover for dishwasher control module. Needed when plastic is cracked, broken, or switch actuators are worn or missing. Protects control board.
This part fixes the following symptoms
-
Touchpad does not respond
See more...
Do-It-Yourself Stories from Customers like You
Dishwasher could not be ran in different modes Ed M. • Lawnsdale , AR • October 22, 2016
I had to replace the plastic schell around the control modguie, manufacture wanted to sell you the complete modgule
Read more
More
$84.43
- Compare At:
-
$101.32
- You Save:
-
$16.89
Out Of Stock
Usually ships within 4 - 14 days
Genuine Frigidaire part
By: Frigidaire
Part Number: 316247700
Secures burner or oven control to the control panel behind the knob. Replace if stripped, missing, or loose to keep control shaft stable and aligned.
Do-It-Yourself Stories from Customers like You
Steim broken Margaret I. • Halls , TN • February 01, 2017
Replace with new switch it was berry easy 10 min. Job
Read more
More
$13.74
- Compare At:
-
$16.35
- You Save:
-
$2.61
Out Of Stock
Usually ships within 4 - 14 days
Genuine Lg part
By: Lg
Part Number: 3551DD2001W
Closes off the bottom of the dishwasher cabinet to protect internal components. Replace if the panel is cracked, missing, or won't stay secured.
More
$135.95
- Compare At:
-
$145.14
- You Save:
-
$9.19
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB01K10008
Cooktop mounting screw secures the cooktop to frame or brackets. Replace if stripped, missing, or rusty to eliminate wobble, rattling, or lifted corners.
Do-It-Yourself Stories from Customers like You
Oven lock failed so self cleaning unit would not engage Alice L. • Martinez , CA • September 17, 2018
Replaced old lock and installed replacement lock and now have a happy wife.
Read more
More
$11.95
- Compare At:
-
$14.22
- You Save:
-
$2.27
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WB1K5200
This replacement mounting screw is used in cooking appliances to fasten components securely. It restores a tight, rattle-free fit so panels, brackets, or burner-related parts stay properly aligned during everyday use.
- Secures appliance components to the chassis or assembly
- Replaces a missing, stripped, or corroded screw
- Helps resolve loose panels, wobbling parts, or vibration noises
- Supports proper alignment of mounted parts
What's included: One screw Install notes:
- Disconnect power at the breaker; for gas units, also shut off gas supply
- Allow the appliance to cool completely before servicing
- Use the correct driver; start threads by hand to avoid cross-threading
- Tighten snugly without overtightening; replace damaged threads or hardware as needed
Do-It-Yourself Stories from Customers like You
I was having error codes F20 and F34 while using the oven and F34 many times when not in use Paul D. • Punta Gorda , FL • March 24, 2021
I did some research on my own and then spoke with the “Pros” at Appliance Parts Pros. Both confirmed the main board needed to be changed. The other less likely item was the oven sensor. I changed the sensor first as it was inexpensive. The error codes continued. Subsequently, I then changed the main board which was slightly difficult. When changing 2 screws hold the board in place on each front corner only. Also suggest you take a picture of wiring. I replaced wiring in place from old board to...
Read more
More
$9.88
- Compare At:
-
$10.87
- You Save:
-
$0.99
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WE01X10137
Seals the unused drum light opening in your dryer cabinet. Replace if missing, cracked, or brittle to contain lint and protect internal components.
More
$40.95
- Compare At:
-
$49.14
- You Save:
-
$8.19
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WZ4X245D
Mounting screw secures range components and panels. Replace if screw is stripped, missing, or damaged during appliance repair or maintenance work.
Do-It-Yourself Stories from Customers like You
The tri element and the 6 inch element stopped working Mark B. • Middleton , MA • August 27, 2016
Went on line to the FAQ and ordered the 2 units suggested. The install was very easy and had the stove back online in 1/2 hour
Read more
More
$24.32
- Compare At:
-
$28.94
- You Save:
-
$4.62
Out Of Stock
Usually ships within 4 - 14 days
Genuine Frigidaire part
By: Frigidaire
Part Number: 387316100
Small sleeve that supports and aligns shafts or levers inside your cooktop. Replace when worn, cracked, or missing to restore smooth operation.
More
$11.95
- Compare At:
-
$14.22
- You Save:
-
$2.27
Out Of Stock
Usually ships within 4 - 14 days
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304464349
Hardware kit for mounting microwave to wall and cabinet. Includes screws, bolts, and washers for secure installation. Replaces lost or missing fasteners.
Do-It-Yourself Stories from Customers like You
I had the kitchen remodeled and demolition team threw away the fixing bracket and mounting hardware at this point i was sitting with a fully functional microwave but no brackets to mount on. Neeraj Q. • San Jose , CA • July 16, 2019
I searched Appliance Parts Pros for the bracket. All I did was put in the Model Number on the Microwave and they had the complete manufacturers drawings available for each part. I placed the order online and the part was delivered in two days. This saved me a few hundred Dollars.
All Parts I received were Genuine Manufacturer Parts.
I thank the team for the wonderful job you are doing.
Read more
More
$52.68
- Compare At:
-
$62.69
- You Save:
-
$10.01
Out Of Stock
Usually ships within 4 - 14 days