10139223 Parts

This temperature sensor monitors internal appliance temperature so the control board can regulate cooling. Replacing a failed sensor restores accurate temperature readings and helps maintain consistent cooling performance. What it does

• Measures compartment temperature and sends the signal to the control board
• Helps the appliance start or stop compressors, fans, and defrost cycles correctly
• Commonly linked to symptoms like erratic temperature, frequent cycling, or temperature-related error codes
• Failsafe: a damaged sensor can cause the unit to run too cold, too warm, or display temperature errors

• Disconnect power before attempting service to avoid shock or damage
• Handle the sensor and wire harness gently; do not pull on wires or bend sensing element sharply
• Reconnect the connector fully and secure routing to prevent pinching or chafing

This splice connector repairs a broken or damaged wire connection to restore reliable electrical contact in your appliance. It's a small, low-profile replacement that helps prevent intermittent power or component failures caused by loose wiring. What it does:

• Joins two or more wire ends to re-establish a secure electrical connection
• Commonly used where a factory wire connection has failed, become corroded, or been cut
• Can stop intermittent operation, loss of power to components, or sparking at a damaged connection
• Suitable for low-voltage appliance wiring repairs when the original splice is compromised

• Disconnect power to the appliance before inspecting or replacing wiring to avoid shock or damage
• Use proper crimping or soldering technique and insulation (heat-shrink or approved electrical tape) per local code

This shim is a small metal spacer used to position and support the dryer drum, helping maintain proper alignment for smooth rotation and quiet operation. It replaces a worn or missing shim to reduce wobble and rubbing. What it does:

• Centers and spaces the drum at the rear support to keep rotation aligned.
• Reduces drum wobble and vibration caused by worn or missing shims.
• Helps prevent metal-on-metal contact that can cause scraping or squeaking noises.
• Supports even drum movement that can improve seal alignment and prevent uneven wear.

• One shim

• Disconnect the appliance from power and gas before any repair.
• Access typically requires removing the dryer cabinet or rear panel; follow OEM disassembly diagrams.
• Inspect adjacent parts (rear drum bearing, glides, rollers) and replace if worn.