8473521 Parts

Specs: 8 - 18 x 0.500

Replacement drum front bulkhead for dryers. Installs at the front of the drum assembly. Needed when original is cracked, damaged, or worn out.

Replacement foot for countertop microwaves. Installs on the bottom to support and level the unit. Order if your original foot is cracked, broken, or missing.

Speednut fastener for ranges and ovens. Secures panels and components. Replace if stripped, missing, or no longer holds parts firmly in place.

This is a replacement hex nut used to secure appliance components and fasteners. It restores proper fastening where a lost or damaged nut causes loose panels or hardware and helps stop rattling or movement. What it does

• Secures panels, brackets, or components to threaded studs or bolts
• Restores proper tension where a missing or stripped nut allows parts to wobble
• Helps eliminate noise from loose hardware and prevents further wear
• Used wherever a matching-thread nut is specified by the manufacturer

• Confirm thread size and type match the original before installing
• Hand-thread first to avoid cross-threading, then tighten with appropriate tool
• Wear eye protection and disconnect power to appliance if working near electrical components
• Do not overtighten; replace any damaged studs or bolts rather than forcing this nut

This part has been discontinued by the manufacturer and is no longer available.

A single #8A x 1/2" screw used to fasten trim, panels, and internal components on compatible appliances. Small but essential, it restores secure mounting and stops loose parts from rattling or shifting. What it does:

• Secures panels, brackets, and trim to the appliance chassis
• Replaces missing, stripped, or corroded screws that cause rattling or loose fittings
• Provides proper thread engagement for consistent, reliable fastening
• Helps maintain alignment of components that depend on a correctly sized screw

• Disconnect power to the appliance before working on any electrical or mechanical components
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and avoid overtightening; snug is usually sufficient for sheet-metal fastening
• Keep removed fasteners in a small container to avoid loss during reassembly