Fc388wec Parts

Color: black. It measures about 4 inches in diameter.

This mounting gasket creates a tight, cushioned seal where a component attaches to its housing or bracket. Replacing a worn seal helps stop leaks and rattles while restoring a secure, reliable connection at the mounting point.

• Forms a seal between two mounting surfaces to help prevent leaks or seepage
• Cushions and isolates vibration for quieter operation
• Helps maintain proper alignment of the mounted component
• Replace if the gasket is cracked, flattened, brittle, or no longer sealing

• Disconnect power and shut off water or gas, if applicable
• Note the gasket's orientation before removal
• Clean and dry both mating surfaces; remove all old gasket material and residue
• Seat the new gasket evenly; reassemble and tighten fasteners snugly without overcompressing; test for leaks/operation

Size; 8-18 x 1/2 inch.

This metal tailpipe directs dryer exhaust from the appliance outlet to the vent system, restoring proper airflow and helping prevent exhaust leakage. It's a direct-fit replacement that reinstates safe venting. What it does

• Channels exhaust air from the dryer outlet to the vent duct to maintain proper airflow
• Helps prevent exhaust leakage behind the dryer that can cause odor or moisture issues
• Stops rattling or misalignment at the dryer outlet caused by a damaged or bent tailpipe
• Supports safe venting performance that can affect drying efficiency

• One tailpipe

• Disconnect power; for gas dryers, shut off the gas supply before starting
• Basic tools (screwdriver/socket) typically required; follow OEM installation instructions
• Ensure the tailpipe is seated and secured to the dryer outlet and vent duct with proper clamps or screws
• After installation, check for leaks, proper alignment, and test dryer operation

This sink flange seal is a rubber gasket that creates a watertight seal between the sink and drain flange to help prevent leaks and water damage. Use it when the flange seal is cracked, flattened, or leaking. What it does:

• Seals the gap between the sink and drain flange to stop water from leaking under the sink.
• Helps prevent sink-edge water pooling and slow drainage caused by a failed seal.
• Reduces chance of odors from trapped water beneath the flange by restoring a tight seal.
• Restores proper fit when replacing a corroded or worn sink flange assembly.

• One sink flange seal (rubber)

• Turn off water supply and disconnect drain components before replacing the seal.
• Remove the drain flange assembly, clean mating surfaces, then seat the new seal evenly.
• Avoid stretching or cutting the seal; replace it if damaged or misshapen.