Gg40t6pf00 Parts

Restore your appliance's factory look with this badge assembly. It replaces a missing, cracked, or faded logo on the refrigerator exterior, delivering a clean, professional appearance without affecting performance or operation.

• Decorative nameplate/logo for the refrigerator exterior
• Replaces cracked, faded, loose, or missing badge
• Restores a clean, factory appearance
• Cosmetic component; does not impact cooling or function

• Disconnect power before servicing the appliance
• Protect the finish; use a plastic trim tool to remove the old emblem if needed
• Clean and dry the mounting area; align with locating marks/holes and secure per your model diagram

This plastic drain valve controls water flow from the appliance, allowing proper draining during normal operation and service. It restores reliable drainage and helps prevent standing water or backups in the drain path. What it does:

• Opens and closes the drain path to release water when commanded by the appliance controls
• Directly addresses symptoms such as slow or no draining, water remaining in the tub, or intermittent drain operation
• Replaces cracked or worn valve bodies that can cause leaks or poor sealing
• Works with the appliance's existing hoses and mounting points to restore proper drain function

• Replace with power disconnected and water supply turned off; follow the appliance manufacturer's service instructions
• Inspect surrounding hoses and seals for wear and replace if needed to ensure a watertight connection
• Tighten fittings to manufacturer torque specs; avoid overtightening plastic threads

This gas control valve with attached thermistor regulates gas flow and provides temperature sensing for safe burner operation. It replaces a failed valve assembly to restore reliable ignition and proper burner control in compatible gas ranges. What it does:

• Controls and meters gas to the burner based on oven/stove commands
• Thermistor monitors temperature or flame-sensing circuits for safe operation
• Commonly used when the oven/stove won't ignite, won't hold flame, or shows inconsistent heating
• Works as the factory valve assembly that interfaces with the appliance's control electronics

• Disconnect power and shut off gas supply before starting any service
• Installation requires basic appliance wiring and gas line experience; use approved fittings and leak-test per local codes
• Do not modify the part; install only in appliances approved for this valve

This door thermistor is a replacement temperature sensor that monitors the interior door area so the refrigerator control can maintain proper cooling. It restores accurate temperature readings to help stabilize fridge performance. What it does:

• Senses temperature at the refrigerator door and sends the reading to the control board
• Helps the control adjust cooling cycles to maintain set temperatures
• Stops false temperature alerts or error codes caused by a failed door sensor
• Common symptom: erratic or incorrect temperature display, improper cooling, or occasional defrost/control errors

• One door thermistor sensor (single sensor only)

• Disconnect power to the appliance before starting any work
• Replace the sensor carefully; avoid damaging the thin sensor tip and wiring
• Secure wiring to prevent pinching when reassembling
• Test the new thermistor per OEM resistance/diagnostic procedures before final reassembly

This short pilot assembly is the gas pilot used to ignite the main burner on compatible natural-gas ranges and ovens. It restores reliable ignition when the original pilot has failed or is damaged. What it does

• Provides the pilot flame that lights the range/oven main burner
• Replaces corroded, clogged, or mechanically damaged pilot components
• Can stop ignition issues like failure to light or inconsistent pilot flame
• Helps eliminate sputtering or unstable pilot behavior when the pilot itself is the cause

• One short pilot assembly (natural gas)

• Turn off gas supply and electrical power before beginning service
• Use proper sealing materials on gas fittings and check for leaks after installation