Kelvinator Duty Moisture Sensor Bags Parts
Genuine Frigidaire part
By: Frigidaire
Part Number: 297216600
Freezer runs constantly or has frost buildup? The defrost thermostat regulates temperature to prevent ice on coils. DIY-friendly repair in 1-2 hours.
This part fixes the following symptoms
-
Too warm
-
Doesn't shut off
-
Fridge runs too long
-
Freezer not defrosting
See more...
Do-It-Yourself Stories from Customers like You
Upright frost free freezer would not keep food frozen (Frigidaire name plate but made by (Electrolux) testing determined the refrigeration system worked but it would not defrost. Kenton K. • Chanhassen , MN • May 31, 2020
Fixed it by replacing the electronic control board. Only 30 min. to fix. (See further down for effort to diagnose the problem.) Most of this "fixing time" was spent removing the control panel to access the control board that is attached to it. My freezer has the control panel located in the top center of the door. The only way to remove the control panel is to pry the panel out of the door using a thin-bladed putty knife.The instructions provided were very good in explaining the process;...
Read more
More
$32.25
- Compare At:
-
$38.05
- You Save:
-
$5.80
Genuine Frigidaire part
By: Frigidaire
Part Number: 5303918202
Freezer frost buildup? Defrost thermostat regulates defrost cycles to prevent ice accumulation. DIY repair takes 15-30 minutes with basic tools.
This part fixes the following symptoms
-
Freezer not defrosting
-
Fridge too warm
-
Freezer section too warm
See more...
Do-It-Yourself Stories from Customers like You
This was for a friend of mine his refrigerator stopped cooling Gary G. • Ofallon , MO • July 12, 2015
This was a 2000 model so rather than just replace the defrost timer which was visibly burnt on the terminals, we just did everything. The cold control, defrost timer, thermostat, defrost heater and the compressor capacitor were all replaced. I had the same issue on my older unit and tore it apart replacing one item at a time over a three month period so on an older one i suggest do it all while it is apart.
Read more
More
$38.95
- Compare At:
-
$46.35
- You Save:
-
$7.40
Genuine Frigidaire part
By: Frigidaire
Part Number: 216731001
Evaporator coils frozen solid? Defrost thermostat senses coil temperature and triggers the heater to melt frost buildup. Straightforward replacement.
Do-It-Yourself Stories from Customers like You
No cooling from refrigerator lights worked but compressor did not run Jeff B. • Ovalo , TX • May 07, 2015
Checked compressor windings - ok. Start relay looked no rattle or burning. Start capacitor seamed ok but hard to check. No 120VC to start relay at any time. Ordered thermistor, and electronic control unit. Figuring it was a bad thermistor not telling the ECU it was warm and to turn on the compressor. Or the ECU was damaged and was not sending the 120v to the compressor. Changed the thermistor first (cheapest part and as Appliance parts pros has a return policy I wanted to start there). ...
Read more
More
$72.95
- Compare At:
-
$86.81
- You Save:
-
$13.86
Genuine Frigidaire part
By: Frigidaire
Part Number: 154290204
Dishwasher not heating or drying dishes? This high limit thermostat monitors water temperature and prevents overheating. Easy DIY fix with basic tools.
Do-It-Yourself Stories from Customers like You
The dishwasher wasnt heating Tina R. • Sedro Woolley , WA • December 26, 2015
I took and ohm meter to the heating element and figured out that was ok. Went to the thermostat and it was toast. Easy fix.
Read more
More
$62.29
- Compare At:
-
$73.50
- You Save:
-
$11.21
Genuine Frigidaire part
By: Frigidaire
Part Number: 154753101
This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.
- Monitors water temperature in the tub/sump and sends readings to the control board
- Helps the control regulate heater operation and determine cycle progress/timing
- Failure can result in no heat or poor drying
- May cause unusually long/short cycles or temperature-related fault codes
What's included: 1 thermistor Install notes:
- Disconnect power at the breaker and shut off the water supply before servicing
- Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
- Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
- Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating
Do-It-Yourself Stories from Customers like You
Dish washer was stuck in never ending wash cycle Carlos E. • Rockford , MI • December 11, 2015
After a bit of testing I found that this thermister was not closing when the water was up to temp, causing the machine to stay in the wash cycle. This was a 5 minute job to change, accessible from under the machine without moving it. Easy fix, good price!
Read more
More
$20.65
- Compare At:
-
$24.37
- You Save:
-
$3.72