30X10093 Parts

This sensor monitors operating conditions and relays accurate feedback to the control so cycles run properly. Replacing a failed sensor helps restore correct operation and prevent erratic behavior or fault codes. What it does:

• Detects a specific operating condition and sends a signal to the control
• Helps the machine regulate cycle timing and performance
• Can cause error codes, cycles that won't start or advance, or intermittent shutdowns when failing
• Lead to inconsistent temperatures or sensing behavior depending on application

• 1 sensor

• Disconnect power (and shut off gas/water, if applicable) before servicing
• Access the sensor; note wire positions and connector orientation
• Install the new sensor in the same location and orientation; seat connectors fully
• Clear any stored faults and run a test cycle per the tech sheet

This replacement igniter is the glow-style heating element that lights the gas burner in compatible gas dryers, restoring reliable ignition so the dryer can produce heat when calling for a cycle. What it does

• Heats to a glowing temperature to ignite burner gas when the dryer starts
• Replaces a cracked, broken, or non-glowing igniter that prevents the burner from lighting
• Common symptom: dryer runs but does not produce heat
• Also used when the igniter shows visible damage or fails continuity checks

• One igniter (glow bar)

• Disconnect electrical power and shut off gas supply before servicing
• Handle the ceramic/element carefully; the glow element is fragile and can break if touched or dropped
• Follow OEM service instructions and replace any suspect mounting hardware or sensors encountered during replacement

Sprocket that connects the motor to the drum drive system in your dryer. Replace if teeth are worn, stripped, or the part is cracked or broken.

Hex washer head machine screw for dryer panel and component installation. Replace missing, stripped, or damaged fasteners on commercial models.

Socket set screw for dryer assembly and component mounting. Replaces lost, stripped, or damaged screws during repairs or maintenance. 5/16-18 thread.

Ball bearing for dryer drum support. Replace if drum wobbles, makes grinding noises, or doesn't rotate smoothly. Verify fit with your model number.

Square shaft key that locks the dryer motor pulley in place. Replace if worn, sheared, or missing to secure the pulley and restore proper operation.

This is a 2-sheave motor pulley belt that connects the drive motor to the pulley system in commercial-style dryers. It transfers rotational force from the motor to spin the drum during the drying cycle. Replace this belt if the dryer motor runs but the drum does not turn, or if you notice squealing, slipping, or visible cracking on the belt.

Replace your dryer's lock washer spring if parts are loose or vibrating excessively. This helical spring washer secures components and reduces noise.