Dwf80f800uws/Aa01 Parts

The Side Mount Kit is an OEM replacement part for Frigidaire dishwashers. It contains mounting brackets, screws, and other hardware required to securely install the dishwasher against cabinetry in a side-by-side configuration. Proper attachment is necessary for stability and safety during operation. 

Symptoms of damaged or missing mounting hardware include:

• Excessive movement or rocking of the dishwasher body
• Potential detachment from cabinets  
• Screws pulling loose from repeated vibrations
• Improper door alignment causing difficulty closing fully

Causes related to normal wear over extended use periods. Damage may occur if weight is applied during improper lifting or installation attempts.  

Compatible models include Electrolux, Gibson, and select Kenmore units.

Replacement screw that secures brackets, shelves, trim, panels, and covers inside your appliance. Install when the original is missing, stripped, or corroded.

Black

Replace your dishwasher door gasket when you notice water leaks, visible wear, or poor sealing. Maintains a watertight seal for efficient operation.

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

Support plate for dishwasher interior mounting. Replaces cracked, broken, or missing plates that secure components. Direct fit for multiple models.

Lower rack roller wheel for dishwashers. Mounts to the bottom rack to allow smooth gliding. Replace if cracked, broken, or worn for proper rack movement.

This #8-32 x 3/8" screw secures appliance panels, trim and components so parts stay aligned and stable during normal use. Its standard size fits threaded holes where a short machine screw is required. What it does:

• Fastens panels, brackets, control trim or small assemblies to the appliance frame
• Restores secure fit when original screws are missing, stripped, or loose
• Helps stop rattling, vibration, and misaligned parts caused by loose hardware

• Use the correct #2 Phillips or appropriate driver to avoid stripping the head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Replace damaged screws with the same size and thread to ensure a secure fit
• Disconnect power or follow appliance safety steps when accessing internal components