Trash Compactor Panel Parts

A replacement front panel frame that restores the microwave's front appearance and secures the control/door area. Designed as a direct-fit exterior trim piece to replace damaged, cracked, or faded front frames. What it does:

• Replaces a cracked, warped, or discolored front trim to restore the appliance's appearance
• Helps maintain proper alignment and fit of the door and control area
• Covers and protects internal edges and mounting points at the front of the unit
• Reduces drafts and visible gaps caused by broken or bent trim pieces

• Disconnect power before starting any repair to avoid electrical hazard.
• Basic disassembly of the outer trim or bezel may be required; keep screws and fasteners organized.
• Handle the new frame carefully to avoid scratches; plastic edges may be sharp.

This complete Door assembly II replaces a damaged or worn refrigerator door to restore fit, seal and appearance. It provides the full door panel and mounting points so the door closes properly and protects cooled compartments. What it does

• Replaces a cracked, dented or misshapen door panel that prevents proper sealing
• Restores door alignment and hinge mounting for smooth opening and closing
• Re-establishes the barrier that helps maintain internal temperature and energy efficiency
• Provides factory mounting surfaces for bins, trim and gasket to secure interior storage

• Disconnect power and remove food and shelves from the door area before starting
• This is a large component; two people and basic hand tools are usually required for safe handling and installation
• Support the door while removing hinge hardware to avoid dropping or bending
• After installation, check door alignment and gasket seating; allow time for the door to settle before final adjustments