Weedeater Pruner Trimmer Head

This is a replacement knob for a trimmer. The plastic bump knob, which is connected to a spring, is used to secure the spool. A bump knob on a trimmer may get stuck or seized and will need a replacement. Before replacing the bump knob, remove the wire from the spark plug to avoid the accidental starting of the engine. Pull off the trimmer head housing and then use a flat head screwdriver to detach the old knob. Rotate it and then remove the component. Make sure the spring is in place then align the knob before rotating and snapping it in place. Take note that pulling the knob off may take extreme force when pulling. Some knobs are screw-mounted and a counterclockwise turn is necessary to unscrew it. This genuine OEM replacement part is sold individually and is compatible with specific trimmer models from Poulan and Weed Eater.

This is the outer cover for a string trimmer housing. It clips into the bottom of the reel and secures it in place behind the central button. It’s constructed from a rubberized black plastic. This plastic is designed to be as durable as possible, while also flexing slightly when it’s under pressure. The cover serves two primary functions. It holds the reel in place and also acts as a mounting point for the central button. While it’s quite durable, it may eventually wear out due to regular use. A few scratches aren’t going to put a cover out of commission, but look for areas where the plastic has been worn through all the way. Replacing the cover is easy. Simply squeeze the old cover and pop it off the assembly. Position the new cover over the reel, then snap it into place. This cover is used primarily on Husqvarna string trimmers but is also used on some Poulan and Craftsman models. This is an OEM part sourced directly from Husqvarna, and it is sold individually.

This is a wound spool assembly that can be used on several models of lawn and garden equipment. The spool assembly is the part that holds the trimming line. It also operates by letting the line feed out when a trimmer or pruner is being used. The wound spool assembly is a component of the cutting head assembly but can be replaced as a single part. This wound spool assembly part experiences a great amount of wear and tear. It's not a bad idea to have an extra available for any needed replacement. If the spool assembly is broken or damaged, it can be replaced in just a few minutes. The first step is to power off the equipment and remove the spark plug wire. The cover should be removed to get access to the wound spool assembly. Switch it out with the replacement part.This wound spool assembly is sold as an individual part. It is a genuine OEM replacement part that is directly sourced from the manufacturer. The spool assembly is designed to be compatible with string trimmers and pole pruners manufactured by Poulan, Poulan Pro, and Husqvarna.