White Westinghouse Refrigerator Ice Maker & Related
Genuine Frigidaire part
By: Frigidaire
Part Number: 241798231
Ice maker stopped making ice? This complete ice maker assembly resolves no ice production and leaking issues. Easy DIY install with video guide included.
Do-It-Yourself Stories from Customers like You
Ice maker stopped making ice. Steve C. • Dripping Springs , TX • September 30, 2019
Well, I got online and found several YouTube videos on how to check what was happening. I have a multimeter and tools. I first replaced the external water filter just to make sure it wasn't that, and it needed it. That wasn't the problem. I then removed the water inlet valve which was really easy. I didn't disconnect the water lines but I did unplug the power plug. Using the ohms setting on the meter, I tested the coil of the valve solenoid. It wasn't open. I checked the voltage at the plug...
Read more
More
$84.63
- Compare At:
-
$113.65
- You Save:
-
$29.02
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304456675
Ice maker not shutting off or making too much ice? A worn lever arm prevents proper shutoff. Simple replacement takes under an hour to restore function.
Do-It-Yourself Stories from Customers like You
Lever arm for the icemaker shutoff was worn and nonfunctional Tom A. • White Heath , IL • December 09, 2016
I found the part on AppliancePartsPros.com . I ordered the part @ 4:00 P.M. and it was on my doorstep the NEXT DAY @ 11:00 A.M.
Simple R & R and I was making ice in an hour!
Read more
More
$49.35
- Compare At:
-
$59.22
- You Save:
-
$9.87
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304469384
This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:
- Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
- Helps restore normal ice dispensing when cubes remain stuck in the mold
- Works with the ice maker's motor/gear train to time ejection during the harvest cycle
- Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes
What's included:
- One ice ejector (ejector arm)
Install notes:
- Disconnect power to the refrigerator before starting any repairs
- Remove the ice maker/cover or access panel as required to reach the ejector
- Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
- After installation, run a test harvest/dispense cycle to correct operation
More
$50.71
- Compare At:
-
$60.85
- You Save:
-
$10.14
Out Of Stock
Usually ships within 4 - 14 days