Thomas H Fort Worth , TX October 17, 2014 Door handle on 2002 model maytag dishwasher broken I called a local repair center who estimated $300+ to fix this. I bought a door handle and door latch for $~100 and fixed my dishwasher in about 10 mins. I ordered the parts on Sunday, they arrived on Tuesday. Very happy with appliance parts pros and would recommend them. Read More... 11 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
Robert B North Hills , CA April 13, 2014 Appliance: Maytag Dishwasher MDB9150AWW Door latch No problem door opens with no effort. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
William L Panama City , FL May 24, 2016 Handle on dishwasher broke & nothing works Got the Handle in short order, viewed repair instructions and fixed it in less than 30 minutes. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Matthew C Jamestown , NC February 09, 2015 Appliance: Model MAYTAG DISHWASHER Front panel had broken/cracked door handle had broken apart as well shame on maytag!!! used poor design and cheap parts no more maytags for our home!!!! I removed the STARHEAD screws holding the inside panel to the outside door. I then separated panel, exposing the six screws needed to CAREFULLY remove the electronics and the soft touch switches. ( Note there is a screw in the center of the board!!!!) You must pull each wire harness off CAREFULLY from the electronics panel, not the ribbon wires.( Make a note of each connection location so you can return them to the correct position.) Then bend the electronic panel toward you. The ribbon wire will hold the panel. The electrical board and the support bracket for the switch panel will snap out. Look for these points along the top and bottom of the board. once you have gotten the electronics and the support bracket off the the panel , remove the rest of the screws that are holding the panel on the metal chassis.( 2 on the far left and two on the far right, 1 in the middle of the support panel. Reinstall the new front panel using the 2 left and 2 right side screws to start, just to hold it in place. Reinstall the support brackets and the board and reconnect the wiring harnesses. You must take your time and proceed slowly. You must do all of this very carefully. When done, replace the black plastic water shield back over the entire assembly. Close up the door panel and replace all screws. There is a video or the handle replacement. Do that last. It is a very easy install. I hope this helps you.....I am NOT a handy guy and I did this.....You CAN do this!!!!!! Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers, Socket Set
Robert P Lincoln , NE August 26, 2016 Broken handle on maytag built in dishwasher Found the replacement part on your site and watched the video to make the repair. A few days later, I fixed it as described. Fast delivery too. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers