Richard B Buda , TX August 08, 2015 Ice auger broken Replaced ice auger. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Brian H Pleasant Lake , MI February 27, 2017 Ice auger broke. Replaced necessary parts. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Harry T Lincolnton , NC May 19, 2015 Motor worked but auger would not turn I initially that the problem was the coupling was either stripped or loosely connected to the auger. Ended up stripping screw head and had to rebuild with new Auger and Screw and changed the coupling out for good measure. Re-assembled and re-installed. Same problem. I then removed ice bin. removed to screws in door and removed drive shaft. Noticed that the spot below washers on shaft was devoid of grease. This indicated the washer slid up, or shaft slid down, depending on your perspective. Re-positioned washer so that more of shaft was exposed and could interface with the coupling. Re-installed ice-bin. Good as new. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Christopher M Akron , OH December 21, 2014 No ice from dispenser Pretty easy fix. The hard part was putting blades back together but you can download the diagram online to see how it goes. By the way,I ordered parts and received email in less than one hour that they were shipped. At my door in less than 40 hours. Nice job folks!! This shop has always been that reliable every time I order from here. Thanks again!! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Jeff L Buckeye , AZ April 14, 2020 Appliance: Whirlpool Refrigerator GS5VHAXWY01 Auger coupling was stripped. All I needed as the auger coupler that connects it with the drive shaft to the ice maker, but the screw attaching the coupler to the auger was corroded and I ended up stripping the screw. So I had to drill out the old screw and scrap the auger. Bought a new auger, screw, and coupler and the repair went well. Re-assembling the ice blades was a little tricky, but a pretty easy repair at the end of the day. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers