Melton R Hampton , VA December 27, 2014 Crush ice maker blade bent I removed the shaft from ice bucket removed the blade below and pulled off bent blade. Put new blade in the bent blade spot put lower blade back on screwed it back into Ice bucket replaced in fridge and now it works perfectly without hanging up. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Kevin M Citrus Heights , CA November 17, 2017 The ice maker would not shut off making ice even when the bin was full Spoke with a representive that diagnosed the problem as a bad control board. After receiving the new control board, I was able to easily perform the replacement by watching the step-by-step instructional video on the website. It is now functioning normally. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Mary B Naperville , IL August 28, 2020 The ice auger support was cracked and the a blade was bent due to a plastic part used to close open bags of chips was caught in the ice dispenser I watched the videos on how to repair different parts of the ice make when it wasn't working. By taking it apart I was able to decipher that the ice auger support was cracked and a blade was bent. I ordered the parts and after watching the video, I was able to repair it myself and saved a lot of money by not hiring a repair person. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Wrench Set