Gene H Overland Park , KS April 15, 2015 Maytag dryer making rattling noise with or without load in drum Unplugged line cord. Removed two phillips screws close to bottom in front and lifted at 30º angle to release top clips on front panel, rotated it aside so as to not disturb door switch wires. Turned drum by hand. Located rattle emanating from blower housing. Removed lint screen and holder with phillips and 1/4" nutdriver. Removed blower housing cover with 1/4" and 5/16" nut driver. Blower wheel's hub was shattered around motor shaft. Ordered new one. Cleaned out lint buildup. Took off retaining ring with external ring pliers. Blower wheel fell off shaft. Installed new blower wheel (line up with flat of motor shaft) and new expanding clip (included) on hub with needle nose pliers. Reinstalled retaining clip and reassembled. Worked like a champ. The buzzer was for a different project. Read More... 101 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Pliers, Screwdrivers