Scott S Janesville , WI October 23, 2014 No cycles were starting Put in a new control assembly. When I got the old one out, sure enough there was a burn on the circuit board. Put a new one and we are going again without needing a service call. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Dennis S Pine Grove , PA May 29, 2017 Our maytag dishwasher would not run i tested the door switches all were good there were instruction to do diagnotic test by pressing a series of buttons it showed low voltage to motor First I turned off the breaker. I unplugged and removed the circuit board. There were some spots on it which appeared to be a little smoked. So I started searching on line. AppliancePartPros.com was the only one that had this part IN STOCK. Their standard shipping claimed average 1.7 days! Sounded good to me. I was amazed when I looked at the tracking info, which stated it was left on my front porch! And there it was, Less than 2 days. I carefully installed the part, and it purrs like a kitten. The machine is in very good shape for it's age, about 17 years old. The price of the board and a little work was well worth saving the expense of a good quality new machine plus the whole removal and installation hassle. Thank you, AppliancePartsPros. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers