Whirlpool Freezer Gasket & Seal

This refrigerator door gasket creates an airtight seal around the door to keep cold air in and warm air out, helping maintain proper temperature and energy efficiency. Replacing a worn gasket restores a reliable seal and prevents frost or moisture issues.

• Seals the perimeter of the refrigerator door for consistent cooling
• Helps reduce frost, condensation, and temperature swings
• Common symptoms include doors not sealing well, warm spots, or excess moisture

• Unplug the appliance before service
• Soften the gasket in warm water to improve flexibility and fit
• Clean and inspect the door channel; start seating the gasket at the corners
• After installation, close the door and check for uniform contact around the seal

This replacement door gasket creates a tight seal between the refrigerator door and cabinet. It restores proper sealing to keep cold air in and moisture out when the original gasket is torn, warped, or leaking. What it does:

• Forms an airtight barrier around the door opening to prevent air leaks
• Helps maintain consistent temperatures and reduce frost or condensation
• Replaces gaskets that are cracked, brittle, misshapen, or not sealing
• Common fix for doors that won't close or seal properly

• 1 door gasket

• Unplug the refrigerator before servicing
• Warm the new gasket in hot water or with low heat to relax folds
• Start at the corners and press the gasket lip into the channel; tighten any retainers evenly
• Close the door and check for even contact all around; adjust hinges if necessary

This refrigerator door gasket seals the door to the cabinet to keep cold air in and humid air out. Replacing a worn gasket restores a tight seal, helps maintain temperature, and reduces frost and energy loss.

• Forms an air-tight perimeter seal between the door and cabinet
• Helps maintain stable interior temperature and humidity
• Reduces frost, condensation, and air leaks
• Resolves: torn or deformed gasket, door not sealing or popping open, moisture around the door, excessive frost or longer run times

• Disconnect power before servicing
• Warm the new gasket to relax folds; use warm water or low heat to ease installation
• Remove the old gasket from the retainer; if screws are present, loosen to replace; seat corners first and press the bead fully into the channel
• After installation, check for uniform contact around the seal; close the door to help the gasket set and adjust door alignment if needed

This is a replacement refrigerator door gasket that seals the door to help maintain consistent internal temperature and improve energy efficiency. It restores a proper seal to reduce cold air loss and protect stored food. What it does:

• Creates an airtight seal around the refrigerator door to prevent warm air intrusion
• Helps maintain stable internal temperature and reduce frost buildup
• Reduces compressor run-time caused by a leaking door seal
• Commonly used when the existing gasket is cracked, torn, warped, or no longer seals

• Inspect the door, liner, and mounting channel for damage or debris before installing
• Clean mounting surfaces and warm or flex the gasket as needed for easier seating
• Apply even pressure around the perimeter; replace any damaged mounting clips or fasteners
• Disconnect power or follow appliance-specific safety steps when working near electrical components

This right-side evaporator cover gasket seals the evaporator cover to help prevent air leaks and reduce frost buildup, supporting consistent cooling and efficient refrigerator operation. What it does:

• Seals the evaporator cover to minimize warm air intrusion and reduce ice accumulation on the evaporator
• Helps maintain stable compartment temperatures for better cooling performance
• Reduces moisture and dripping that can cause water pooling inside the cabinet
• Can address symptoms such as increased frost on the evaporator, higher-than-normal temperatures, or water inside the fresh food/freezer area

• Disconnect power to the appliance before beginning any repair
• Remove necessary interior panels or shelves to access the evaporator cover per the service manual
• Seat the gasket fully around the cover flange; inspect the cover and seating surface for damage or debris