Tim H Homeworth , OH December 15, 2018 Cold water inlet valve would not shut off in Kenmore washer Replaced the water inlet valve assembly. I was surprised how easy it was to do. A putty knife to release the panel and a screw driver to release 2 clips. Ordered the parts on Tuesday, received them the next day and the washer was back in business. The wife is happy, and when she's happy, eveybody's happy! Glad I found your site!! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Constance M Baltimore , MD October 13, 2020 Appliance: Model 8212545RP Water connection to the washer was not working properly. I had a hole in the red and blue water fill hoses. I did the label work myself which was very easy unscrewing them off and screwing them back to the washer and to the water line much cheaper than having a company to come out and do the labor for you. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers
Brandy H Colorado Springs , CO August 25, 2020 Appliance: Whirlpool Washer WTW8500DC2 Whirlpool Cabrio displayed lf would not complete a wash cycle. Purchased water inlet valve and new hot and cold water hoses. Unscrewed about 5 screws that were holding the top of the washer in place then slide the top forward and up. Released the control top it popped off no screws. Disconnected the wires attached and unscrewed 2 screws holding the valve in place the popped that off. Popped in a new valve and repeated the process in reverse. Boom done! Very simple works like new! Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Socket Set
Douglas G Augusta , GA January 23, 2022 Fill Hoses. Replaced the older hoses for peace of mind since the washing machine is on the second floor. I very much liked the color-coded for future maintenance. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers
Thomas N Pleasant Mount , PA April 05, 2026 Appliance: Maytag Washer MVWB765FW1 Leaking water from center bottom of machine - Didn't see any other leaks in machine. No grinding transmission noise. Assumed seal on transmission shaft was bad, since it was a central leak down the rotor. It was a little more difficult to dissemble than the video showed, but not too bad. Got it all back together and seems to be working well. No leaks yet. Didn't need washer in parts diagram - was already on the transmission. Also the drain pump filter was not necessary, it can just be cleaned. Read More... Do-It-Yourself Rating: Repair Time Estimate: 2+ hours Tools: Nut Drivers, Pliers, Screwdrivers, Socket Set