Sharon H Port Huron , MI December 05, 2014 Appliance: Whirlpool Washer WTW6600SW2 Agitator wasn't functioning properly and "growling" I replaced the washer plate and new screw/washer part. Easy fix and back up and running in ubder 10 minutes. Read More... 31 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
Andrew S Marietta , GA March 21, 2014 Washplate not rotating. Spline had been worn out. Removed cap on top of washplate by prying it off with screwdriver. Removed single bolt holding washplate and lifted washplate off of shaft. Removed round metal wear plate on bottom of washplate and placed on new washplate. Slid new washplate onto shaft aligning splines. Replaced bolt and snapped on cap. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers, Socket Set
Dan W Claremore , OK September 19, 2016 Washplate splines were stripped on the washer Found the washplate on ApplianceParts.com and ordered it with no problems at all.. The Wasplate actually arrived the next day! Installation was about 3 minutes and works perfectly! Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
Jay N Brazil , IN March 21, 2015 Washer would not agitate Thought it was electronic board washer would try to sense the load size but would not agitate.splines gone on washer plate easy fix pop off round cap off washer plate remove one bolt transfer wear plate under plate to new plate install 5 minutes Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
Ellen W Egg Harbor Township , NJ August 08, 2016 Clothes weren't getting clean Reloaded the agitator and bolt Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set