Whirlpool WPA3223101 Tube Insert (Compression Fitting) OEM Part

Replaced the water tube that went from the plastic tubing to the ice cube tray. Found that even though it was the same exact length as the original, there was only an extremely small gap from the end of the tube to a splash board. This may have been the root cause of my problems.

Thanks to AppliancePartsPros.com, the repair video and parts department--this senior citizen who had never worked on any appliance--Thanks to their detailed video and easy to follow instructions I can honestly say, "I did it myself!" (I moved slower than the man in the video and needed pliers because I don't have the strength needed) But I will be a return customer if ever I need help in the future! Thank You Appliance Parts Pros!!

I replaced the fill tube, line insert and speed clip. It should be noted, that the how-to video showed this all being done from the rear of the fridge. However, when I first replaced the tube, it did not go through the back wall of the freezer and into the icemaker. The rear panel in my freezer is not lined up well where the tube comes in. I needed my wife to gently push on the fill tube while I guided it into alignment. As of this morning, we have ice again and no leaks.

Remove a small cover with two screws. Pull the tube out, slide the new one in. Reconnect water tube with the clip.