Michael V Massapequa Park , NY November 23, 2014 Appliance: Model DUET WASHER The buttons were broke and the machine would not start I purchased the parts from appliance parts pros and followed their repair video, to complete the repair myself. It took about 10 minutes, with complaining kids in the background. It was simple, and saved me a ton of money. Read More... 58 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Jeffrey N Burnsville , MN March 02, 2015 The parts were brittle from being old start button had broken off as well as the power on button Watched video, and installed the part Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Michael D Granada Hills , CA November 10, 2017 Appliance: Whirlpool Washer GHW9200LW0 The start button was pushed into the control panel and could not start machine I'm glad there was a video and detailed instructions on how to access the control panel. I was not sure if the button itself broke, or worse the attachment point on the control panel was the broken part. The only way to tell was to disassemble the machine to access the control panel. I needed to know to be able to order the correct part. Unfortunately I found that it was the very thin plastic piece of the control panel that had broken. I had to order the full panel. I received it a few days after my order and was able to once again disassemble the top end of the machine, remove the control panel, swap over all of the buttons from the old to the new panel and reassemble the machine. The entire process took about 15 minutes. It was as easy as it could be once I understood how to access it. The Video was the key component. My machine is once again as good as new. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Ron A Iron Mountain , MI April 25, 2015 Buttons were broke on control board due to brittle plastic and poor design! HAD TO BUY WHOLE NEW CONTROL BOARD TO FIX MINOR PROBLEM DUE TO PART I NEEDED WAS NO LONGER MADE! Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Robin H Castro Valley , CA October 25, 2014 Start button was broke Went online, read about how to fix the problem. Watched a you tube video and then ordered the part. Part arrived in 4 days, rewatched the you tube video and then replaced the part which took less than 15 minutes. Appliance parts pros made the whole process beyond simple. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers