Gerald P Hanover , PA August 18, 2017 Appliance: Maytag Gas Dryer PYG2300AWW I have a gas dryer that had been converted to lp gas and i needed to convert it back to natural gas First and foremost... MAKE SURE THE GAS IS TURNED OFF AND THE DRYER IS UNPLUGGED BEFORE PERFORMING ANY WORK!!! Serious injury, property damage, or worse...death could occur if not. I have a Maytag dryer. This information is based on my dryer. Products differ from manufacture to manufacture. I suggest you research your specific appliance for details pertaining to your application. Youtube is a good place to get information and video tutorials. Although there wasn't a video specific to my dryer, I found several videos that gave me a general idea of what I was looking for. The top has 2 clips, on the left and right front, that hold the top down. You can't see these clips, but if you lift or pry up gently they are slightly visible. Take a flat head screw driver and push in on the clips, from the front of the dryer, which will release the top from the clips, and then lift the top up. Now, remove the front panel by removing the two 1/4" screws at the top that connect the front panel to each of the side panels. The door switch on the front panel also has to be removed in order for the front panel to be removed completely. Mine was held in place by a clip, which I just popped the switch out of it, and left it hanging on the side panel. With the front panel removed, my burner was on the bottom left of the dryer. I removed the burner and located the orifice behind the burner tube, which I had removed after detaching the burner from the dryer. I replaced the orifice with the correct one that had come in the conversion kit I had ordered from AppliancePartsPro.com. I also had to replace the vent leak limiter, which is located on the side of the burner, and that part was also included in the conversion kit. Now reattach the burner tube back to the burner and then the burner back to the dryer. While you still have the front panel off, this is a good time to clean any lint that may have collected inside the dryer cavity and lint trap. Turn the gas on, but, DO NOT PLUG INTO ELECTRIC OUTLET AT THIS POINT! Apply a solution of soap and water to the fittings you replaced and check for leaks. If there is a leak, bubbles will appear. Re-tighten your fittings if so, and then repeat leak test. Now you can reattach your front panel. Don't forget to reattach the door switch. Close the top. Now you can plug in the dryer to the electric outlet. Give it a test run for a few minutes to insure it's working properly. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Nut Drivers, Screwdrivers, Wrench Set
Joe H Meshoppen , PA December 05, 2014 L needed to change the dryer from propane to natural gas Purchase at conversion kit Installed it in 30 mins. the parts came in two days, very happy customers Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Wrench Set