Jay B Ballwin , MO September 29, 2015 Appliance: Model WFW0499SW01 Whirlpool wfw9400sw01 had defective fill valve [for the 2nd time in 7 years] and dispenser lever noted to have crack & replaced as well Old lever was gently pried off at each end while pinching retention axle clips. New unit snapped in place easily. Fill Valve was removed easily after removal of a single retention screw in the back. [and after turned OFF the Hot & Cold water supplies any removing hose attachment fittings from the two fill valve nipples]. The two electrical connectors [color coded] are then easily disconnected. The Fill Valve then is pushed to the side & up and then back into cabinet and gently lifted up and the connecting hose clip squeezed and moved off the Fill Valve nipple and the Fill Valve was removed. Installation was the reverse. The Dispenser Unit NOW, again, fills quickly; ALSO the softener & bleach areas get "bathed as well [again]. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers, Socket Set
Charles C Huntley , IL June 24, 2019 Appliance: Model W9200 Divertor arm jam in operation Talked with lady in order dept {robin?} who helped narrow down the part needed. Before I could order we were cut off. I ordered online, received the next day and repaired the washer. Great service. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
John W L Geneva , FL January 17, 2020 One turn on the lever arm was pulling up and would not let the wash machine turn on Replace the lever control arm and motor. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Pliers, Screwdrivers