George M Palmyra , VA October 19, 2014 Appliance: Maytag Washer- Horizontal Axis MAH4000AWW The plastic inner door leaked caused by a rubber rug smashing into the lower portion of the door Replaced the door assembly Before taking the door off the washer I painted the hinges with a little finger nail polish to enable the hinges to be replaced correctly. Used petroleum jelly on the outside of the vent grommet (18) so it could easily be slipped on to the door liner. Also used the petroleum jelly on the bottom of the vent tube (17) to fit into the vent grommet. Most difficult chore was rearranging the plastic lock support (3) to fit the door, the attaching the vent tube and finally using needle-nose pliers to rearrange the latch spring (2) on the lock support (for a dummy 20 minutes). Had to look at the picture diagram. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers