Dean H Rochester , MN April 08, 2014 Bad Panel Dishwasher would not start. Only some of the panel lights would work. Before it quit working the LED display that shows how long until the wash was completed started to go out too. 15 minute job to remove the screws to get to the panel and replace it. There are videos on youtube to help you. Simple ribbon cable connection. Fixed my problem. Save $100 service call. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Kenneth C Piedmont , SC March 16, 2014 My dishwasher fell victim to the ‘fat finger’ syndrome and I found the two most PUNCHED keys broken Tools Needed: Star head driver & hex nut driver 1) Turn off power at circuit breaker 2) Remove door inner cover screws and separate (Star driver) 3) Remove Op panel screws & let hang but supported (hex driver) 4) Remove hex screw on PCB cover (cable connection ) 5) Slide connector toward you to remove old flat cable (remove old Op panel) 6) Connect new flat cable red coat down 7) Reassemble in reverse order Difficultly Level: Easy Time: 20’’ Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Paul D Belleview , FL January 14, 2017 Appliance: Maytag Undercounter Dishwasher MDBH965AWB40 Flashing 9 error code I replaced the control panel. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers
Michelle B Gulfport , MS February 02, 2015 Appliance: Model MAYTAG 300 QUIET SERIES DISHWAHER Control panel stopped working Watched a couple of videos, narrowed down the problem, talked to some great folks at Appliance Parts Pro and then once the new control panel came in - Easy Peasy! just like the video.... the hardest part was keeping the top and bottom of the door to stay apart long enough to do the job, so I just stuck the silverware tray in the gap and Viola, all fixed! Thanks guys! Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers, Socket Set
Tim O Keller , TX December 19, 2014 Control panel and handle were cracked and broken Replace both parts. took about 15 minutes. Very easy repair. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers