Dustin E Auburn , AL October 10, 2020 Oven not getting to baking temperature Oven would broil but not get to a baking temperature. Baking element was burned through in one spot. Replaced element, temp sensor and terminal block. Works like a champ and cakes are getting baked!!! Read More... 11 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers, Socket Set
Gwendolyn I Columbia , SC May 03, 2020 It was taking over 30 min for the oven to heat to 350F. The oven would not keep the temperature at a constant The lower heating element was replaced. Read More... 7 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Raymond L Cutler Bay , FL March 06, 2022 Appliance: Whirlpool Electric Range WEE730H0DS0 The oven overheated no matter the temperature reading. The broiler element would not shut off, the bottom element was OK. Access to the back panel (6 screws) took 2 minutes, both parts are right up front. The temperature sensor tested bad. Replaced the sensor, and fuse (preventive). The broiler element still malfunctioning, will order a new one. Repair time noted is only after new parts in hand. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
William B Crown Point , IN February 25, 2020 Oven temp was off Changed the sensor. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers
George F Lambertville , NJ November 28, 2025 Appliance: Model KITCHEN AID OVEN/STOVE MODEL # KSEG700ESS2 Kitchen aid stove/oven would take over an hour to reach an oven temperature of 350f Replaced oven bake element by removing the floor of the oven covering the element. Only 2 screws hold the oven floor in place. Unplugged stove, removed back plate covering the electrical connection also 2 screws. Disconnected the oven element. Removed the 2 screws holding the element to the floor and removed the electric oven element. Only 6 screws, total, to remove. Reverse the process and you’re done. Oven reaches operating temperature in about 15 minutes. I didn’t need to change the temperature sensor. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers