Whirlpool WP74009254 Fan Control Switch OEM Part

After looking at several YouTube videos that were only moderately helpful for my particular model, I disconnected the power at the breaker, disconnected the wires below the cooktop to the junction boxed lifted the whole unit out, including the fan assembly. I flipped it upside down and took off the screws holding the unit to the glass top. Although the new fan switch did not look the same as the original switch, the new switch does fit. The new switch did not come with a hex nut. The old hex nut was just slightly bigger than threads on the new switch. So, I needed to go to a few hardware stores to find a hex nut that would fit. I finally found one at Ace Hardware. After reassembling everything, I realized that I did not need to take the whole unit out and flip it like some videos had suggested. I just needed to lift the unit high enough to put some wood under the unit to hold it up above the hole in the counter. Doing that would have saved some time. The fan now works great with the new switch.

Replaced switch with a like component.

Replaced the bearings and seals. Except for pounding the axle out of the drum, it went quite well. I had to soak the axle/bearing in rust remover over night.

Removed the old switch and ordered a new one from AppliancePartsPros.com. I chatted with a representative who found the replacement in less than 5 minutes. My thermador parts are no longer in production so it is a little harder to find manufacturer's fro replacement parts. You made the process quick, painless and the part arrived in two days! Very, very good service!!!!

To replace the switch you have to disconnect all the wiring and take out the cooktop. Open up the bottom support case to take the switch out. The switch cannot be taken out from the top. It was much harder than I thought. Put the new switch in and the fan was working again.