Gary E Smyrna , GA March 11, 2016 Appliance: Whirlpool 30" Gas Slide-In GW399LXUS05 Certain buttons on touch pad membrane (timer most notably) failed Replacing the switch membrane restored full function. Relatively easy. Had to pull stove out just a few inches to provide access to two side screws holding control enclosure. Then four screws on bottom edge just above oven door. Then a screw above each burner control. And one screw on the top edge at each corner (right screw additionally holding a ground wire). That allowed the structure to come out. Helper required to hold structure while I worked to unplug the old switch-membrane from circuit board and then peel it off front. Installed new switch-membrane by first plugging in its two cables, and then peeling adhesive backing off for adhering new switch-membrane to control surface. Read More... 16 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Mike E Wyandotte , MI October 22, 2014 Some of the functions didn't work on touch pad Removed touch pad and found that where the wire connects to the assembly the circuit was broken. Replaced touchpad and works beautiful ! had to bake a turkey to celebrate! Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Nicholas A Sterling Heights , MI July 30, 2016 Range Went so good and I'm happy and I never thought I'd be easy but I did it Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
George H Summerfield , FL April 06, 2014 Appliance: Whirlpool 30" Gas Slide-In GW399LXUS04 SWITCH NOT WORKING, GOT WET???? INSTALLED NEW SWITCH MEMBRANE, WORKING LIKE NEW. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
April S Schertz , TX July 16, 2019 Touchpad on oven was not working Replaced the touchpad Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Nut Drivers, Screwdrivers