Whirlpool WP53-1096 High Limit Thermostat (Limit Cut-Off) OEM Part

When I pulled out the dryer from the wall, I could see dust/lint had accumulated everywhere and the vent system was compromised. I vacuumed up the dust/lint accumulation outside and then inside the vent system. I then opened the lower cabinet to clean and check its condition. I removed the water steamer bottle and its sub-assembly and then the drum. After cleaning and inspecting components — both visually and with a multi-meter I determined the problem was the appliance doing what it was designed to do. It was shutting off because of restricted flow out the vent caused by dust/lint accumulating. I further confirmed this by returning power and switching the dryer on with the cabinet still open and the drum still removed. I could observe the igniter heating to a glow and then the gas valve delivering fuel followed by ignition. I ran the unit for approximately a minute to see if it would cycle off or continue. It operated normally. I replaced the drive belt on the drum as part of routine service as the appliance cabinet was open and it was due. I redesigned and installed a new vent system to prevent problems in the future. It was a three-hour job in addition to the dryer work of an hour. I ordered a number of parts to have on hand as I generally perform my own repairs. I found the information on your website to be helpful in determining which parts to the stock based on the problems others had and your troubleshooting information. I also want to compliment you on your prices as I found other sources charging twice the amount for the same part. Shipping was fast and as advertised. I have you listed as my source for major appliance parts.

Replaced the solenoids and the cycle sensor.