Whirlpool Warming Drawer Parts

Replaces a cracked, broken, or missing control knob on your warming drawer's control panel. Restores reliable setting selection and complete appearance.

Oven won't heat or stops heating? This thermal fuse thermostat opens the circuit at unsafe temperatures. Common fix after self-clean mode failures.

This is a temperature control switch used in a warming drawer to regulate the heat setting. It allows the user to select and maintain the desired warming temperature. Replace this switch if the warming drawer does not heat, stays on one temperature regardless of the setting, or does not respond when the control is adjusted.

Warming drawer won't heat or power on? This thermal fuse cuts power when temperatures exceed safe limits. Straightforward replacement fix.

Replacement drip tray rail pan for warming drawers. Collects and channels condensation away from internal components. Needed when original is cracked, warped, or missing.

This is a sealed RTD (resistance temperature detector) sensor used in ranges and ovens to accurately monitor internal cooking temperatures. The sensor sends temperature readings to the control board, which regulates heating elements accordingly. Replace this sensor if the oven is not heating to the correct temperature, displays error codes related to temperature sensing, or cycles on and off erratically.

This warming drawer insert restores the removable drawer that keeps cooked food warm until serving. It replaces the drawer component for select built-in warming drawers to return proper fit and function. What it does:

• Provides the removable inner drawer used to hold and retrieve warmed dishes
• Re-establishes correct drawer fit and sliding function in the warming drawer cavity
• Helps maintain heated food placement while the drawer is closed
• Addresses symptoms like a missing, damaged, or ill-fitting drawer insert

• One warming drawer insert

• Turn off power to the appliance before servicing and allow surfaces to cool
• Remove existing drawer per manufacturer instructions before installing the replacement
• Align drawer slides and guide rails, then slide fully into place to confirm proper fit

Replacement rack for warming drawer. Installs inside drawer cavity to hold dishes and pans. Order if original rack is bent, warped, or missing.

This silicone gasket seals the area around the control panel on a range or oven, preventing heat and moisture from reaching sensitive electronic components. It provides a flexible, heat-resistant barrier between the cooking cavity and the controls. Replace it if it is cracked, compressed, or missing, which can lead to control board damage or erratic oven behavior.

Wire harness assembly routes power and control signals between warming drawer components. Replaces damaged, frayed, or worn wiring harness connections.

This oven door gasket creates a tight seal between the oven door and cavity to help retain heat for even cooking and improved energy efficiency. Designed to replace a worn or damaged gasket and restore proper door closure. What it does:

• Seals the oven door to minimize heat loss and help maintain set temperatures
• Helps prevent cooking inconsistencies, long cook times, and burnt door edges caused by leaks
• Reduces heat transfer to surrounding cabinetry and floor surfaces
• Restores a snug door closure and reduces energy waste

• One oven door gasket

• Only install when the oven is cool and power (or gas) is disconnected for safety
• Remove the old gasket by pulling from the channel; press the new gasket into the channel evenly around the door
• Ensure the gasket's sealing lip faces the oven cavity so it seats properly when the door closes
• If the door is heavy or awkward to handle, get help to avoid injury or damage

Warming drawer door gasket seals the drawer to maintain consistent temperature and prevent heat loss. Replace if torn, cracked, or loose fitting.