After the dish cycle is done and the water drains out, the dishwasher will start to fill once again, it looks like this is casued by the float switch, can you confirm this?
Answer Hi. If the Float part # 9743070 itself has crud build up in the tub hole (normal) this stops the float stem from lifting up and down smoothly. Remove the lower rack and lift the float out of the tub to check for this and crud under the float top. Remove the bottom panel and look at the float switch cover. If it is not latched closed then this allows the float stem to be misplaced and off to one side. This will bend the float switch lever to be activated all the time. It is best to replace the float switch itself part # 9743413. Thank You.
This dishwasher sometimes has a lot of water coming out from the botton of the door , like an overflow!!! The funny thing is that it does not do it all the time.I already chech and there is nothing stock under the float .
Answer Ralph, Did you also check the float stem W10207863 and float shaft 9743070 for a build up of debris , causing the flaot to "stick" ? If alls OK, you may want to consider a fill valve 9744468, you may have an issue with the solenoud or diaphram, allowing a slow reaction and allowing an intermittent overfill. Thanks