Parts for Bosch MUM6680 UC/03: 01 - Body & Component Assemblies Parts

This blender access cover is the exterior access panel that closes the blender compartment, keeping internal components protected and the appliance looking finished. Replaces a worn or cracked access cover to restore a secure seal and appearance. What it does:

• Covers and protects the blender housing and internal components from dust, spills, and accidental contact
• Prevents gaps that can let debris into the blender cavity or interfere with operation
• Helps maintain the appliance's finished appearance and safe user access
• Commonly replaced when cracked, broken, warped, or missing

• Designed to be installed with basic hand tools; follow the appliance service manual for exact steps
• Disconnect power to the appliance before servicing to avoid injury
• Inspect mounting tabs and surrounding trim for damage; replace any broken fasteners

This timer knob is a direct-fit control knob that lets you set and adjust your appliance's timer quickly and precisely. It restores a firm grip and accurate timer control for appliances with a worn or broken knob. What it does:

• Provides a tactile grip to turn and set the appliance timer
• Engages the timer shaft so selections register properly
• Restores safe, predictable timer operation when the original knob is cracked or loose
• Helps eliminate slipping, off-center rotation, and difficulty selecting timer settings

• One timer knob

• Install on the timer shaft by aligning the knob opening and pressing firmly until seated
• If the knob won't seat, power off the appliance and inspect the timer shaft and retaining clip for damage
• Do not force a damaged knob onto the shaft; replace damaged timer shafts or retainers first

This replacement bottom case provides the appliance's lower structural housing, protecting internal components and helping maintain proper alignment. Durable molded construction restores support and helps contain minor drips for safer operation. What it does:

• Forms the appliance's lower housing to support internal parts and wiring
• Protects motor, pump and electronics from debris and contact
• Helps channel minor leaks away from controls and towards drain areas
• Restores proper fit and alignment of the appliance cabinet

• Disconnect power and water supply before beginning work
• Keep fasteners and clips organized; verify all seals and gaskets are seated during reassembly
• Inspect adjacent components (pump, hoses, wiring) for wear while unit is open

This replacement dryer drum belt wraps around the dryer drum and drive pulley to transfer motor rotation to the drum, restoring normal tumbling and enabling proper drying action. What it does

• Transfers motor torque to the drum so clothes tumble during operation
• Keeps the drum rotating smoothly by maintaining proper belt tension
• Worn, stretched, or broken belts can cause the drum to stop turning, slip, or make squealing sounds
• Replacing the belt addresses tumbling and abnormal noise symptoms related to belt failure

• One dryer drum belt

• Disconnect power (and gas if applicable) before beginning any repair
• Access the drum per your model's service instructions—belt routing varies by design
• Inspect idler pulley(s) and motor pulley for wear and replace as needed to prevent repeat failures
• After installation, manually rotate the drum to verify correct routing and tension before restoring power

These are replacement carbon motor brushes that restore electrical contact between the motor and commutator, helping return proper motor function and reduce sparking or intermittent operation. What it does

• Transfers electrical current to the motor commutator so the motor can run.
• Replaces worn brushes that cause reduced power, intermittent operation, or motor failure to start.
• Helps reduce excessive arcing or sparking at the commutator when worn.
• Restores reliable motor performance when deterioration of the original brushes is the cause.

• Disconnect power before starting any repair; work only on a fully de-energized appliance.
• Replace both brushes at the same time for even wear and best performance.
• Inspect the commutator for heavy scoring or pitting; clean or service if needed for best results.