Parts for Bosch NHT722: 01 - Complete Parts

This bridge grate holds cookware steady across adjacent burners, letting you move pots and pans smoothly on the cooktop while providing a continuous cooking surface. It restores stable support and appearance to the cooktop area. What it does:

• Replaces a damaged, chipped, or missing grate to regain stable cookware support
• Bridges two burners to make sliding heavy pots and pans easier and safer
• Helps maintain even support so cookware sits level during cooking
• Restores the cooktop's finished look when the old grate is cosmetically worn

• One gray bridge grate

• Allow the cooktop to cool completely before removing or installing the grate
• Lift the old grate straight up and set the replacement into the same position; no tools are typically required
• Confirm the grate seats fully and is level before turning burners on
• Clean with non-abrasive cleaners; avoid harsh scrubbing that can damage the finish

M3 washer for cooktop assemblies. Secures components and provides proper spacing. Replace if washer is missing, cracked, or worn from repeated use.

This gas manifold pipe routes gas from the inlet/regulator to the cooktop valve assembly, ensuring each burner receives fuel. Replace a damaged manifold to restore safe, even gas delivery and reliable burner operation. What it does

• Delivers gas to the burner valve assembly so each burner can ignite and maintain flame
• Use when burners fail to light, flames are uneven, or the manifold is visibly corroded or damaged
• Helps prevent gas leaks caused by cracks, holes, or loose connections when installed correctly
• Works as part of the cooktop's gas distribution system in 4-burner ranges

• Turn off the gas supply and electricity to the appliance before beginning service
• Use proper seals/gaskets and torque fittings to manufacturer specs; do not overtighten
• After installation, test for leaks with a gas-safe method and verify all burners light and operate normally

This is a valve seat that fits inside the gas valve assembly on a range or cooktop burner. It provides a tight seal to regulate gas flow and prevent leaks when the burner is turned off. Replace this part if you detect a gas smell near the burner controls or if the burner flame cannot be properly adjusted.

Replace worn cooktop burner gasket seals to prevent gas leaks and ensure proper flame control. Verify compatibility with your model number before ordering.

M3.9 x 9.5 sheet metal screw for cooktop assembly. Secures interior panels and mounting brackets. Order replacement if original is stripped or missing.

M3.9 x 9.5 sheet metal screw for cooktop assembly. Secures interior panels and mounting brackets. Order replacement if original is stripped or missing.

High voltage cable for cooktop electrical connections. Measures 500mm (19.7 inches) long. Replace if cable is damaged, frayed, or corroded.

High voltage cable for cooktop electrical connections. Replaces damaged, frayed, or worn cables. Essential component for safe appliance operation.

M3.9 x 9.5 sheet metal screw for cooktop assembly. Secures interior panels and mounting brackets. Order replacement if original is stripped or missing.

M3.9 x 9.5 sheet metal screw for cooktop assembly. Secures interior panels and mounting brackets. Order replacement if original is stripped or missing.

M4 x 50mm screw for cooktop assembly and mounting. Replace missing, stripped, or damaged screws during installation or repair of your cooktop unit.

Replacement mounting bracket for cooktops. Secures the cooktop unit to countertop or cabinet. Order a new bracket if yours is bent, broken, or missing.