Parts for Gaggenau VL023-707: 01 - Complete Parts

M4 rubber gasket creates watertight seal and reduces vibration around fasteners. Replace when worn, cracked, or leaking. Verify fit with your model number.

This is a right-side holder or endcap bracket that secures an internal component in place within the microwave. It provides structural support and proper alignment for the part it holds. Replace this holder if it is cracked, broken, or missing, which can cause the supported component to shift or rattle during operation.

This is a mounting holder used in a range vent hood to secure internal components such as filters, panels, or ductwork in place. It attaches to the rear of the hood assembly and provides stable support. Replace this holder if it is broken, bent, or missing, which can cause loose or rattling components inside the hood.

Metal angle bracket for appliance mounting and structural support. Replaces cracked, bent, or missing brackets. Secures components in place.

This terminal connector provides a secure electrical connection for appliance wiring, replacing a worn or damaged spade-style terminal to restore reliable power flow. It fits into the appliance's existing terminal block for a lasting repair. What it does:

• Replaces a damaged or corroded spade terminal to re-establish a solid electrical connection
• Helps eliminate intermittent power, arcing, or overheating at the wiring junction
• Works where a right-angle terminal is required to connect a wire to the appliance terminal block
• Compatible with standard insulated or non-insulated spade-style wire terminations

• Disconnect power at the circuit breaker or unplug the appliance before inspecting or replacing terminals
• Verify terminal orientation and fully seat the connector on the mating spade to ensure a tight fit
• Use proper crimping or soldering techniques if attaching bare wire; avoid loose or exposed conductors

This is a metal pin used in a range vent hood assembly. It serves as a fastener or hinge point that secures components in place during operation. Replace this pin if it is bent, broken, or missing, which can cause loose or misaligned hood parts.