Parts for Admiral GT1883PEKW: 01 - Compressor Parts

This genuine replacement screw secures appliance panels and components to restore proper fit and reduce rattling or movement. Use it when a missing or damaged screw prevents panels, brackets, or controls from staying tight. What it does:

• Fastens panels, brackets, or assemblies to the appliance frame
• Helps stop vibration noise and loose parts caused by a missing or stripped screw
• Restores factory fit where an original screw is lost or damaged
• Compatible with common interior and exterior mounting locations as specified by the manufacturer

• Use the correct matching screw hole and thread engagement; do not force a misaligned screw
• Hand-start the screw to avoid cross-threading, then tighten with the proper driver
• Replace any stripped or damaged mating hardware for a secure fit
• Disconnect power before working near electrical components and follow all safety instructions in the appliance manual

Size: 8-32 x .312 inch.

Fastener screw

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

(SOLENOID NOT AVAILABLE MUST ORDER ICE DOOR KIT 12001991)

Fastener screw

This genuine replacement screw secures appliance panels and components to restore proper fit and reduce rattling or movement. Use it when a missing or damaged screw prevents panels, brackets, or controls from staying tight. What it does:

• Fastens panels, brackets, or assemblies to the appliance frame
• Helps stop vibration noise and loose parts caused by a missing or stripped screw
• Restores factory fit where an original screw is lost or damaged
• Compatible with common interior and exterior mounting locations as specified by the manufacturer

• Use the correct matching screw hole and thread engagement; do not force a misaligned screw
• Hand-start the screw to avoid cross-threading, then tighten with the proper driver
• Replace any stripped or damaged mating hardware for a secure fit
• Disconnect power before working near electrical components and follow all safety instructions in the appliance manual

Condenser seal that cushions and seals the condenser assembly to the cabinet, helping reduce vibration and directing airflow for more consistent cooling performance and quieter operation. What it does:

• Cushions the condenser to reduce vibration and rattling noises
• Seals the condenser perimeter to help direct airflow through the condenser coils
• Helps prevent rubbing and abrasion between the condenser and cabinet
• A worn or missing seal can contribute to increased noise or reduced cooling efficiency

• Disconnect power to the appliance before beginning any repair
• Remove the lower access panel or kickplate to access the condenser area
• Peel out the old seal and press the new seal fully into the channel or onto the condenser flange for a snug fit
• Inspect condenser fins and surrounding parts during installation; do not use solvents or unapproved adhesives