Parts for Electrolux FCFI308CBSA: 02 - Backguard Parts

This electronic control is the main console board that manages the appliance's user interface and key operating functions, restoring reliable control of settings, cycles, and display feedback. What it does

• Receives input from the touchpad/knobs and sends commands to heating, motor and valve systems
• Controls timing, cycle selection and display readouts so the appliance runs selected programs
• Can resolve symptoms like unresponsive controls, blank or garbled displays, or incorrect cycle behavior
• May clear intermittent errors caused by a failed or erratic control board

• One electronic control board

• Disconnect all power before beginning service to avoid shock or damage
• Handle the board by its edges and avoid static discharge; use an anti-static wrist strap if available
• Verify connector seating and wire harness orientation during reinstallation

Range not heating, display blank, or buttons unresponsive? This control board manages oven functions and temperature. Moderate DIY repair in 30-45 minutes.

This is a replacement mounting screw used to secure the dual safety valve assembly on compatible gas ranges and ovens. It restores proper fastening so the valve stays firmly in place during operation. What it does

• Secures the safety/dual gas valve to the appliance chassis or manifold
• Prevents valve movement that can interfere with burner operation or alignment
• Commonly replaced when original screw is missing, stripped, or damaged
• Matches OEM thread size and length for correct fit and retention

• One (1) screw, size 10-16 x 0.486

• Disconnect power and shut off gas supply before starting work; follow all safety procedures
• Thread carefully to avoid cross-threading; do not overtighten — snug to OEM torque specification
• Inspect surrounding mounting holes and hardware; replace any stripped or damaged parts for a secure fit

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.