Parts for Electrolux GCFG3059BFA: 02 - Backguard Parts

The Bushing is an OEM part for Frigidaire cooktops. This part serves as an interface between the control knob and the appliance, ensuring smooth operation and protecting both the knob and the control panel from wear and tear. The bushing fits snugly around the valve's stem, reducing friction and providing stability as the knob is turned to adjust the heat settings of the cooktop.

Causes of a bad Bushing can include degradation from frequent use, exposure to high heat, or accidental damage during cleaning or use, which can lead to the bushing becoming loose or worn out.

Symptoms of a malfunctioning Bushing include:

• Loose-feeling knobs that wobble or are difficult to turn
• Excessive wear or visible damage to the knob or panel area
• Difficulty in achieving precise temperature control
• Unusual noise when turning the knobs

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

Range not heating, display blank, or buttons unresponsive? This control board manages oven functions and temperature. Moderate DIY repair in 30-45 minutes.

This electrical wire harness routes power and signals between components to restore proper appliance operation. It replaces a damaged or burnt harness to help eliminate intermittent power loss or component failure caused by broken wiring. What it does:

• Connects controls, sensors, and motors so signals and power flow correctly
• Replaces frayed, burnt, or disconnected wiring that can cause intermittent operation
• Helps stop failures like non-working controls, lights, or accessory components
• Preserves OEM connector fit and routing for reliable reconnection

• One replacement electrical wire harness

• Disconnect power to the appliance before starting any repair
• Verify wiring routing and connector orientation before disconnecting original harness
• Secure harness away from heat sources and moving parts during installation

This is a replacement mounting screw used to secure the dual safety valve assembly on compatible gas ranges and ovens. It restores proper fastening so the valve stays firmly in place during operation. What it does

• Secures the safety/dual gas valve to the appliance chassis or manifold
• Prevents valve movement that can interfere with burner operation or alignment
• Commonly replaced when original screw is missing, stripped, or damaged
• Matches OEM thread size and length for correct fit and retention

• One (1) screw, size 10-16 x 0.486

• Disconnect power and shut off gas supply before starting work; follow all safety procedures
• Thread carefully to avoid cross-threading; do not overtighten — snug to OEM torque specification
• Inspect surrounding mounting holes and hardware; replace any stripped or damaged parts for a secure fit

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.