Parts for Ge ZIDS240PASS: 02 - Cabinet Parts

This adjustable foot replaces a worn or damaged leveling leg to stabilize and level your appliance for safe, even operation. It restores a steady base and helps prevent rocking, vibration, and uneven cooking or door alignment. What it does

• Replaces the appliance's adjustable leveling leg to raise or lower one corner for a level fit.
• Helps stop rocking and reduce vibration that can cause noise or movement during use.
• Can correct uneven doors, misaligned drawers, or uneven cooking surfaces caused by a tilted appliance.
• Fits where the factory leveling foot has become stripped, cracked, or worn.

• One adjustable foot.

• Follow the appliance manufacturer's service instructions; disconnect power or gas supply and remove cookware or oven racks before working on the unit.
• Support the appliance when lifting or tilting; use a second person or appropriate jack to prevent tipping.
• Hand-thread the foot into the mounting bracket; adjust height gradually until the appliance sits level on a flat floor.

This temperature sensor (thermistor) senses cabinet/evaporator temperature so the control can maintain proper cooling. Replaces a failed sensor to help restore accurate temperature readings and stable refrigerator operation. What it does:

• Measures internal temperature and sends readings to the control board
• Helps control compressor and fan cycling for consistent cooling
• Commonly associated with refrigerators that run continuously, cool inconsistently, or show incorrect temperature
• Can affect defrost cycles if the evaporator reading is incorrect

• Disconnect power before accessing components to avoid electrical shock
• Handle the sensor and lead carefully; avoid kinking or sharp bends in the wire
• Ensure the connector is fully seated and any mounting clip is snug but not overtightened
• Some models require removing interior panels or the evaporator cover for access

This fan housing secures and directs airflow around the refrigerator fan, helping the unit move air efficiently for proper cooling. It replaces a damaged or cracked housing to restore correct fan alignment and airflow. What it does:

• Provides a secure mounting and protective enclosure for the fan and motor
• Directs airflow to improve cooling and reduce hot spots
• Prevents fan contact with other components and helps reduce vibration noise
• Commonly replaced for cracked housing, broken mounting tabs, or fan misalignment causes poor airflow

• One fan housing

• Disconnect power before beginning any service and verify the appliance is de-energized
• Access may require removing rear or interior panels; keep hardware for reassembly
• Inspect fan blades and motor when installing; replace damaged components as needed
• Handle edges carefully and avoid overtightening fasteners to prevent cracking