Parts for Gaggenau KG260-214: 02 - Component Assemblies & Fascia Panel Parts

This is a sealing bushing that fits around the gas tube on a range to prevent gas and air leaks at the connection point. It creates a tight seal where the gas supply line passes through the appliance housing. Replace this seal if you detect a gas odor near the connection, notice signs of wear or deterioration, or if the seal has become hardened or cracked.

This is a sealing component designed to fit around the gas valve area of a range or oven. It prevents gas and heat from escaping at the valve connection point, ensuring a safe and proper seal. Replace this seal if you notice gas odors near the valve, signs of heat damage around the connection, or if the old seal has become brittle or cracked.

This electrode is used in gas range burner ignition systems. It generates a spark to ignite the gas when the burner is turned on. Replace this part if the burner clicks but fails to light, produces weak or inconsistent sparks, or shows visible cracks or carbon buildup on the electrode tip.

This main gas supply tube routes fuel from the appliance inlet to the manifold, restoring safe gas delivery for cooktops and ranges. Replace a damaged or leaking tube to stop gas odors and restore proper burner operation. What it does:

• Directs regulated household gas from the inlet to the appliance manifold and valves.
• Stops common symptoms like visible leaks, gas odor near the appliance, or burners failing to light due to supply interruption.
• Provides the factory-shaped routing needed for correct fit and clearance in the appliance chassis.
• Works with factory fittings and gaskets to maintain a sealed gas path when installed correctly.

• Shut off the gas supply and electrical power before beginning any service.
• Use factory-specified gaskets, fittings, and leak-detection methods; do not reuse damaged seals.
• After installation, test all connections with an approved leak test and verify burners operate normally.

This spark module generates the electrical spark needed to ignite gas burners on your range. It sends timed electrical pulses to the spark electrodes when you turn on a burner. Replace this part if your gas burners won't light, clicking sounds are continuous, or there's no spark when turning burner knobs.

A small support bracket that secures the mounting strip and helps hold appliance panels and components in proper alignment for reliable operation. Replaces a worn or damaged bracket to reduce rattling and improve fit. What it does

• Supports and secures the mounting strip that attaches panels or trim to the appliance
• Keeps panels, trim, or adjacent components aligned and stable
• Helps prevent movement, vibration noise, or gaps caused by a loose or broken bracket
• Commonly replaced when the bracket is cracked, bent, or missing

• One mounting strip bracket

• Disconnect power (and water, if applicable) before servicing the appliance
• Use appropriate hand tools; mounting screws or clips may be required
• Handle panels and sharp sheet metal carefully to avoid cuts or damage
• Follow the OEM service manual or instructions for exact removal and reassembly steps