Parts for Electrolux GCCI3647ASA: 02 - Control Panel Parts

Replace a faulty electric cooktop control board when burners won't heat, display is blank, or buttons are unresponsive. Moderate difficulty repair.

Replace your cooktop downdraft filter to maintain proper ventilation and air quality. Change when clogged or every 6 months. Verify fit with your model number.

This electronic control board manages a refrigerator's user interface and core functions so the appliance responds correctly to settings and temperature changes. Replacing a faulty board can restore control and resolve erratic operation. What it does:

• Interprets user inputs from the console and runs the refrigerator's control logic
• Sends signals to start the compressor, fans, and defrost cycle as needed
• Monitors and responds to temperature-sensor readings to regulate cooling
• Can stop erratic behavior caused by failed or intermittent control electronics

• Disconnect power at the breaker or unplug the appliance before servicing
• Handle the board carefully; avoid static discharge and contact with circuit traces
• Remove any protective panels or covers to access the control board; keep fasteners for reinstallation

This electronic control board is the appliance's main printed circuit board that controls functions and user inputs, restoring reliable control and proper cycle/feature operation when the original board fails. What it does:

• Receives user commands and runs the appliance's control programs
• Manages timing, sensors, and output signals to motors, valves, heaters, or compressors
• Common symptoms: unresponsive touchpad or buttons, blank or erratic display, cycles that won't start or complete
• May resolve intermittent operation or incorrect cycle behavior caused by a faulty board

• One electronic control board (main PCB) as shown

• Disconnect power before starting — risk of shock or damage if powered
• Handle the board by its edges; avoid touching components or connector pins to prevent ESD damage
• Verify connector seating and wiring harness alignment during reinstall; do not force connectors

Wire harness assembly for electric cooktops. Connects electrical components and controls. Replace if wires are frayed, damaged, or connections are loose.

This terminal block provides the appliance's main wiring connection point, securely joining the incoming power leads to the unit's internal wiring for reliable electrical contact. It restores a solid, safe power feed when the original connector is damaged or worn. What it does

• Holds and secures incoming power conductors to the appliance wiring harness
• Provides firm electrical contact to prevent intermittent power or arcing
• Commonly replaced for loose, melted, or burned terminals or after a short or power-fault
• Helps restore normal power delivery when appliance will not power on due to a failed connection

• One terminal block assembly

• Always disconnect house power at the breaker or unplug the appliance before servicing
• Match wire positions to the appliance wiring diagram and tighten terminals firmly
• Inspect surrounding wiring and strain relief for heat or damage; replace any compromised components

This replacement screw is a single fastener used to secure appliance panels and components. It provides a simple, durable connection for routine repairs and maintenance where the original screw has been lost or damaged. What it does:

• Secures trim, panels, brackets, or small components in place
• Restores proper fit where a missing or stripped screw causes rattling or loose parts
• Matches OEM fit when used as the specified replacement screw
• Helps maintain appliance safety and alignment when installed correctly

• Use the correct screwdriver or bit to avoid cam-out and damage
• Tighten until snug; avoid overtightening to prevent stripping or cracking
• Disconnect power before servicing if the screw secures electrical components
• Compare to the original part before installation if fit or length is critical