Parts for Maytag CWE4020ACB: 02 - Control Panel (Cwe4020acb, Cwe4700acb) Parts

This part has been discontinued and we no longer have any in stock

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This rotary selector switch lets users choose cycles or settings from the appliance control panel, restoring reliable selection and control responsiveness when the original switch is worn, loose, or unresponsive. What it does:

• Rotates to select cycle, temperature, or function positions on the control console.
• Sends the selected position signal to the appliance control so the unit runs the chosen program.
• Common symptoms: knob won't turn smoothly, selections don't change, intermittent or no response from the control.
• Replacing a damaged switch can eliminate loose or erratic selector behavior.

• Disconnect power before beginning any repair to avoid shock or injury.
• Remove the control panel and knob to access the switch; retain screws and fasteners for reassembly.
• Disconnect wire harnesses carefully—do not pull on wiring; use proper tools to release terminals.

This shaft-bit generator is a replacement drive shaft component that transfers motor rotation to the appliance's moving assemblies, restoring proper mechanical motion and reducing noise from damaged or worn shaft parts. What it does:

• Transfers rotary motion from the motor to the driven components for normal operation
• Helps maintain alignment and smooth rotation of connected parts
• Worn or broken units can cause grinding, rattling, or loss of movement
• Replacing a failed shaft can stop intermittent operation and restore reliable performance

• High-level replacement only: remove power before accessing internal assemblies
• Follow appliance-specific disassembly steps; secure panels and wiring before removing the old shaft
• Inspect adjacent bearings, seals, and mounting hardware; replace any damaged items

This factory fastener secures panels, trim, or brackets on your appliance. Replacing a missing or stripped screw restores a snug, rattle-free fit and keeps components aligned for proper operation and a clean, finished appearance.

• Fastens exterior panels, trim pieces, or internal brackets to the appliance chassis
• Replaces lost, damaged, or stripped hardware
• Helps prevent vibration, rattling, and gaps between parts
• Common signs you need this screw: missing hardware, loose or misaligned panel/trim, stripped head or threads

• Disconnect power before servicing; also shut off the gas supply
• Use the correct driver; start the screw by hand to avoid cross-threading
• Tighten snugly—do not overtighten to prevent stripping or cracking adjacent parts
• Repair or replace the mounting point before installing