Parts for Frigidaire MRT13CREW5: 02 - Door Parts

Color: White

The Freezer Door Gasket is an OEM part for Frigidaire refrigerators. This gasket creates a seal around the freezer door to prevent warm air from entering and cold air from escaping, ensuring the freezer maintains its optimal temperature.

Causes of a bad freezer door gasket can include wear and tear over time, exposure to harsh cleaning chemicals that degrade the material, or physical damage from frequent use or mishandling.

Symptoms of a bad freezer door gasket include:

• Noticeable gaps or cracks in the gasket
• Frost buildup inside the freezer
• Increased energy consumption
• The freezer door not closing properly

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This refrigerator door gasket seals the fresh-food compartment to help maintain proper cooling and reduce energy loss. It restores a tight door seal to help keep food fresher and the refrigerator running efficiently. What it does:

• Replaces a worn, torn, or deformed door seal to stop cold air leakage
• Helps maintain consistent internal temperature and reduce frost buildup
• Reduces strain on the compressor caused by a poor door seal
• Addresses symptoms like warm spots near the door, excessive frosting, or higher energy use

• One refrigerator door gasket

• Remove power to the appliance before replacing the gasket
• Clean the door flange and allow it to dry before installing the new gasket
• Work around the full perimeter, easing the gasket into the channel; avoid forcing or trimming unless OEM instructions specify
• If the gasket is stiff, warm it gently (per OEM guidance) to aid fitting; avoid open flames or excessive heat

This inner door panel replaces the plastic interior liner that covers a refrigerator door, restoring a clean finish and proper support for door bins and hardware. It's a direct-fit OEM panel that repairs cracked, warped, or damaged door interiors. What it does:

• Restores the interior surface of the refrigerator door and provides mounting points for door bins and shelves
• Replaces cracked, split, or warped inner liners that can trap moisture or prevent proper door closure
• Secures door hardware and helps maintain a sealed, insulated door cavity
• Improves appearance by replacing scratched, stained, or discolored door interiors

• Disconnect power to the appliance before starting any repair
• Remove the door and any attached bins or hardware to access fasteners; save and reuse existing screws/clips unless damaged
• Handle panel edges carefully to avoid cracking; align clips or screw bosses and fasten snugly without over-torquing

Note: In some applications, this door shelf bar requires you to cut the length to fit. Dimensions: Approximately 23.16" x 1.12"

The Door Shelf Bar is an OEM part for Frigidaire refrigerators. It is designed to secure items on the refrigerator door, providing additional storage space and helping to keep items organized and easily accessible. The sturdy construction ensures that it can hold bottles, jars, and other items securely. It measures approximately 31 inches in length. 

You should replace the door shelf bar if it becomes damaged or worn out. Common causes include regular use, accidental impacts, or the weight of heavy items over time, which can cause the bar to crack or break.

Symptoms of a bad door shelf bar include:

• Items falling from the door shelf
• Visible cracks or breaks in the bar
• Difficulty keeping items securely in place
• The bar not fitting properly or staying attached

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

The Right Hand Door Shelf Support is an OEM part for Frigidaire refrigerators. This support bracket holds the door shelf in place, providing stability and ensuring that items stored in the door compartment remain secure.

Causes of a bad door shelf support can include wear and tear from regular use, physical damage from overloading the shelf, or breakage due to impact when opening or closing the door. Over time, the plastic material can also become brittle and crack.

Symptoms of a bad door shelf support include:

• Door shelf sagging or detaching from the door
• Difficulty in securing items on the shelf
• Visible cracks or damage to the support bracket
• Items falling out when opening the door

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

The Door Shelf Support is an OEM part for Frigidaire refrigerators. This part supports the door shelf, providing a sturdy base to hold various items such as bottles, jars, and condiments securely in place on the refrigerator door.

Common causes of a bad door shelf support include regular wear and tear, overloading the shelf with heavy items, or accidental damage. 

Symptoms of a bad door shelf support include:

• The door shelf sagging or tilting
• Items falling off the shelf
• The shelf not staying securely in place
• Visible cracks or breakage in the support

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Left side door shelf support. Color: White. Measures about 1 3/4 inch x 1 3/4 inch. For the right hand side order 3206150.

The Door Shelf Support is an OEM part for Frigidaire refrigerators. This part holds and secures the door shelf in place, providing support for the items stored on the shelf. 

Causes of a bad door shelf support can include regular wear and tear, overloading the shelves, or physical damage from impacts. 

Symptoms of a bad door shelf support include:

• Shelves not staying in place or becoming loose
• Cracks or breaks in the support material
• Difficulty in securing the shelf to the door
• The shelf tilting or falling off the door

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Note: In some applications, this door shelf bar requires you to cut the length to fit. Dimensions: Approximately 23.16" x 1.12"

This part has been discontinued and is no longer available.

Color: White

The Door Handle is an OEM part compatible with Frigidaire refrigerators. This component serves as the primary means of opening and closing the refrigerator door, offering both functionality and aesthetic appeal. This handle measures approximately 17 x 1".  This white handle comes with block 218396700

Symptoms of needing to replace the door handle include:

• The handle becoming loose, wobbly, or detached from the door
• Cracks, chips, or other visible damage to the handle
• Difficulty in gripping or operating the handle smoothly

Causes of a faulty door handle can include physical impact or mishandling during use or cleaning, general wear and tear over extended periods, or issues with the internal mounting hardware or mechanisms.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore refrigerator models. 

The Screw is an OEM replacement part for Frigidaire refrigerators. This small but essential component is used to secure various parts of the appliance, such as panels, brackets, or internal fixtures, ensuring the refrigerator's structural integrity and proper operation.

Over time, screws may become loose, stripped, or corroded due to regular use, environmental factors, or maintenance work. A damaged or missing screw can lead to misaligned parts or reduced stability of the appliance.

Symptoms of a bad or missing screw include:

• Loose or wobbly components within the refrigerator
• Panels or fixtures coming apart or misaligned
• Difficulty securing parts during maintenance or repair
• Rattling or unusual noises during operation

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This replacement butter dish restores a clean, secure storage area for butter and small spreads in the refrigerator door. It keeps butter contained and helps prevent odors and spills for everyday use. What it does:

• Replaces a cracked, broken, or missing butter dish in the refrigerator door dairy compartment
• Holds a stick or small portions of butter and keeps them from contacting other foods
• Helps contain crumbs and minor spills for easier cleaning of the door shelf
• Provides a neat, designated spot for butter to improve organization

• One butter dish

• No special tools required; remove the old dish from the door shelf and snap or slide the new one into place
• Clean the door shelf area before installing to ensure a secure fit
• Handle carefully to avoid chipping the plastic during installation
• If the dish doesn't seat easily, verify it is aligned with the door shelf guides before forcing

This replacement screw secures appliance components so brackets, shelves, trim, or panels stay firmly in place. Install a new screw when the original is missing, stripped, or corroded to restore a tight, rattle-free fit.

• Fastens brackets, panels, trim, or covers to the cabinet or liner
• Helps maintain alignment and reduce vibration and noise
• Direct replacement for a missing, rusted, or stripped fastener
• Use wherever your model's parts diagram specifies this screw

• Disconnect power before servicing; shut off water if working near water lines
• Match thread and length to the original location as shown in your model's parts diagram
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening (especially into plastic)
• Retain and transfer any original spacers or clips used with this fastener

The Handle Mounting Block is an OEM part for Frigidaire refrigerators. This component anchors the refrigerator door handle assembly while also reinforcing the door structure.

Causes of a bad mounting block can include cracks developing from repeated opening/closing stresses, broken fasteners loosening its installation, or residual damage during door replacement or repair attempts.

Symptoms of a bad handle mounting block include:

• Loose, sagging or misaligned door handles
• Doors difficult to open or not staying securely closed/latched
• Noisy rattling coming from the door handle area
• Cracks or breaks visible in the mounting plastic

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

Specs: 10-16 X 0.500

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.