Parts for Thermador MC17: 02 - Frame Parts

This actuator is the small control motor that moves internal components to change positions or routes within the appliance, restoring proper mechanical motion and cycle operation. What it does:

• Moves dampers, doors or internal levers so the appliance can change modes or direct flow
• Enables cycle components to engage at the correct time for normal operation
• Commonly replaced when cycles fail to advance, modes don't change, or mechanical parts are unresponsive
• Works as the electromechanical interface between control signals and moving parts

• Disconnect power before inspecting or replacing the actuator
• Handle the motor and wiring harness gently to avoid connector or gear damage
• Use basic hand tools; keep track of screws and any clipped linkages during removal

Secures the top of your microwave door to the cabinet for proper alignment. Replace this bracket if cracked, broken, or worn to restore stable door operation.

Secures the top of your microwave door to the cabinet for proper alignment. Replace this bracket if cracked, broken, or worn to restore stable door operation.

Secures the top of your microwave door to the cabinet for proper alignment. Replace this bracket if cracked, broken, or worn to restore stable door operation.

Secures the top of your microwave door to the cabinet for proper alignment. Replace this bracket if cracked, broken, or worn to restore stable door operation.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Replacement light bulb for your microwave interior or range hood. Replace when burnt out or dim. Verify compatibility with your model before ordering.

A molded shield that protects and positions the dishwasher motor/micro-switch assembly so controls operate reliably and wiring stays clear. Helps prevent contact damage and keeps the switch area properly isolated for safe operation. What it does:

• Shields the motor or micro-switch from debris and accidental contact
• Keeps switch actuator aligned for consistent on/off operation
• Helps prevent shorting or wear of nearby wiring and components
• Supports reliable switch mounting and repeatable performance

• One replacement switch shield (single piece as shown)

• Designed to mount around the motor/micro-switch area
• Inspect surrounding wiring and connectors; replace any damaged insulation before reassembly
• Disconnect power at the breaker or unplug the appliance before starting work
• Use basic hand tools; avoid forcing plastic tabs to prevent breakage

Fix a microwave that won't start or respond to controls with this control module switch. Restores proper electrical operation when the original switch fails.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.