Parts for Thermador MC25: 02 - Frame Parts

This actuator is the small control motor that moves internal components to change positions or routes within the appliance, restoring proper mechanical motion and cycle operation. What it does:

• Moves dampers, doors or internal levers so the appliance can change modes or direct flow
• Enables cycle components to engage at the correct time for normal operation
• Commonly replaced when cycles fail to advance, modes don't change, or mechanical parts are unresponsive
• Works as the electromechanical interface between control signals and moving parts

• Disconnect power before inspecting or replacing the actuator
• Handle the motor and wiring harness gently to avoid connector or gear damage
• Use basic hand tools; keep track of screws and any clipped linkages during removal

Panel mounting screw for microwaves, ovens, ranges, and warming drawers. Secures interior and exterior panels. Replace if stripped, missing, or damaged.

This genuine mounting support bracket secures appliance panels and components to maintain proper alignment and stability. It helps restore correct fit and reduces movement that can cause noise, misalignment, or rubbing during operation. What it does:

• Secures panels or assemblies to the appliance frame to prevent shifting and vibration
• Restores proper alignment to doors or panels that sit uneven or rub
• Reduces rattling or knocking caused by loose or damaged mounting points
• Helps maintain seal integrity by keeping components in the correct position

• Replace only with the identical bracket; orientation and fastener locations should be checked before removal
• Use appropriate hand tools; avoid over-tightening fasteners which can strip threads or deform the bracket
• Disconnect power and, if applicable, water supply before servicing to reduce risk of shock or injury
• If other mounting hardware is damaged, replace those fasteners as needed for a secure repair

This part has been discontinued by the manufacturer and is no longer available.

Replacement light bulb for your microwave interior or range hood. Replace when burnt out or dim. Verify compatibility with your model before ordering.

This mounting plate secures internal components and panels for proper alignment and stability, helping reduce vibration and rattling while keeping parts correctly positioned for reliable operation. What it does:

• Provides a stable mounting surface for internal assemblies and control components
• Keeps panels and brackets aligned to prevent rubbing and noise
• Helps stop loose components that can cause vibration or intermittent contact
• Restores proper fit and finish after panel removal or repair

• One mounting plate

• Disconnect power (unplug unit or switch off circuit breaker) before installing
• Use appropriate hand tools (screwdriver, nut driver) and keep fasteners organized
• Inspect surrounding parts and gaskets; replace any damaged fasteners or clips

Phillips pan head mounting screw for cooktops and ranges. Replace this zinc-coated fastener if lost, stripped, or corroded during appliance repair.

This part has been discontinued by the manufacturer and is no longer available.

A molded shield that protects and positions the dishwasher motor/micro-switch assembly so controls operate reliably and wiring stays clear. Helps prevent contact damage and keeps the switch area properly isolated for safe operation. What it does:

• Shields the motor or micro-switch from debris and accidental contact
• Keeps switch actuator aligned for consistent on/off operation
• Helps prevent shorting or wear of nearby wiring and components
• Supports reliable switch mounting and repeatable performance

• One replacement switch shield (single piece as shown)

• Designed to mount around the motor/micro-switch area
• Inspect surrounding wiring and connectors; replace any damaged insulation before reassembly
• Disconnect power at the breaker or unplug the appliance before starting work
• Use basic hand tools; avoid forcing plastic tabs to prevent breakage

This part has been discontinued by the manufacturer and is no longer available.