Parts for Ge AZ75E12EACM1: 02 - Motor, Heater & Base Pan Parts

Fix weak airflow or loud noises from your air conditioner with a new propeller fan blade. Restores proper air circulation across coils for better cooling.

Rubber cushion that mounts between the air conditioner motor and housing to reduce vibration and noise. Replace if cracked, compressed, or missing.

Fix weak airflow or no cooling in your air conditioner with this centrifugal fan replacement. Restores proper air circulation. Moderate DIY repair.

Replacement front panel for room air conditioners. Covers the front housing and control area. Needed when original panel is cracked, broken, or missing.

Drain cover for room air conditioners. Installs over the drain opening to prevent debris entry. Replace if cracked, broken, or missing.

Replacement drain tray for room air conditioners. Collects condensation beneath the unit. Order a new pan if yours is cracked, broken, or missing.

This fan housing seal is a molded gasket that cushions and seals the refrigerator fan housing to reduce air leaks and dampen vibration. It helps maintain proper airflow and can reduce fan noise or frost buildup near the evaporator. What it does:

• Seals the fan housing to direct airflow through the evaporator assembly
• Cushions the fan housing to reduce vibration and rattling noise
• Helps prevent warm air bypass that can cause frost or uneven cooling
• Supports consistent fan performance and quieter operation

• One fan housing seal

• Intended for use around the refrigerator fan housing; location fits your model prior to installation
• Remove power to the appliance before accessing internal components
• Handle carefully to avoid tearing the gasket; ensure seating is even for a proper seal
• If other damaged or worn components are found, replace them as recommended by the manufacturer

This fan housing seal cushions and seals the fan housing to the cabinet, helping maintain proper airflow and reduce vibration and noise. It restores the seal between the fan housing and refrigerator cabinet for more efficient operation. What it does

• Seals the gap between the fan housing and cabinet to direct airflow through evaporator coils
• Helps reduce fan vibration and operational noise when properly installed
• Can prevent air leakage that reduce cooling efficiency
• Useful when the original seal is torn, flattened, or missing

• One fan housing seal

• Disconnect power to the appliance before starting any repair
• Remove the fan housing or access panel as needed to reach the seal; clean mating surfaces before installing
• Press the seal into place evenly; replace if excessively stretched or damaged

AC won't stay running? This thermal overload protector safeguards the motor and compressor by opening when temperature or current rises too high.

This high limit thermostat is a safety device that monitors the heating element temperature in a room air conditioner with a built-in heater. It shuts off the heater if the temperature exceeds a safe threshold, preventing overheating and potential fire hazards. Replace this thermostat if the heater stops working, cycles erratically, or if the unit shuts off unexpectedly during heating mode.

This insulated lead wire provides a reliable electrical connection between components in the appliance, helping restore power flow to heating elements, switches, or motors. Durable insulation resists heat and abrasion for safer operation. What it does:

• Carries electrical current between terminals and components
• Replaces damaged, frayed, or corroded wiring that can cause intermittent operation
• Restores proper connection to heating elements, motors, or control switches
• Helps prevent shorting and arcing when correctly installed

• Disconnect power to the appliance before inspecting or replacing wiring.
• Verify correct wire routing and terminal orientation before tightening connections.
• Use proper crimping or terminal tools and replace any damaged connectors.

Special mounting screw for air conditioner assembly. Replace if screw is stripped, missing, or damaged during maintenance or installation work.