Parts for Jade RJRG3010A: 03 - Door Parts

This 10-32 terminal block nut fastens wire lugs to the appliance's terminal studs. Replacing a missing, stripped, or corroded nut restores a tight, reliable connection and helps prevent heat damage or intermittent power at the connection.

• Secures wire lugs to a 10-32 terminal stud for a solid electrical connection
• Restores proper clamping force when the original nut is stripped, corroded, or missing
• Helps address loose/burned terminal connections, heat discoloration, or intermittent power at the block
• Suitable for terminal block and similar 10-32 stud applications on compatible appliances

What's included: One 10-32 nut Install notes:

• Disconnect power at the breaker or unplug the appliance before servicing
• Inspect the terminal block, studs, and wiring for heat damage; replace any damaged components
• Clean threads and start the nut by hand to avoid cross-threading; tighten firmly without overtightening
• If the stud turns while tightening, hold it with an appropriate tool to protect the block

Mounting screw secures panels, brackets, and trim to the appliance frame. Replace if screw is stripped, missing, or damaged to restore secure fastening.

This 8-18 x 5/8-inch screw secures dryer panels, brackets, and covers. Replace missing or stripped fasteners to restore a tight fit and stability.

This door bottom retainer secures the lower edge of the appliance door to the door assembly for a proper seal and alignment, helping the door close evenly and preventing gaps or movement during use. What it does

• Holds the bottom edge of the door in place on the door assembly
• Keeps the door aligned so it closes evenly and seals correctly
• Prevents the door from sagging, shifting, or allowing drafts
• Addresses symptoms like uneven door closure, loose bottom edge, or rattling at the door base

• One door bottom retainer

• Disconnect power (and water, if applicable) before starting any repair
• Removing the door panel or lower trim may be required; keep track of fasteners
• Use appropriate tools and avoid overtightening fasteners to prevent damage